Search

This paper proposes a quasi-resonant step-up DC-DC converter to provide the DC-link voltage for piezoelectric transmitters (PZETs). The resonance not only provides a soft-switching condition for the converter switches, but also helps to decrease the converter element sizes for marine applications. Operation modes of the proposed converter are discussed. The current and voltage of the converter components are derived analytically, and hence the converter gain is obtained. The performance of the proposed high-step-up, high-power density converter is examined through a comprehensive simulation study. The simulation results demonstrate the soft-switching operation and short transient time required for the converter to reach the reference output voltage. The converter output voltage remains unchanged when an inverter with a passive filter is placed at its output while supplying the PZET. The proposed DC-DC converter is prototyped to validate the converter gain and soft-switching operation experimentally. The converter gain and soft-switching results in simulation are well matched with those of the experimental tests. The converter efficiency in three different switching frequencies is obtained experimentally. The power density of the proposed topology is determined via the designing of a printed circuit board. The experimental results demonstrate the appropriate gain and efficiency of the converter in the tested power range. [ABSTRACT FROM AUTHOR]

Decaying DC (DDC) offset current mitigation is a vital challenge in phasor current estimation since it causes malfunctioning/maloperation of measurements and protection systems. Due to the inductive nature of electric power systems, the current during fault inception cannot change immediately and it contains a transient oscillation. The oscillatory component acts similar to an exponential DC signal and its characteristics depend on the X/R ratio of the system, fault location, and fault impedance. DDC attenuates accurate phasor estimation, which is pivotal in protection systems. Therefore, the DDC must be eliminated from the fault current (FC) signal. This paper presents an overview of DDC mitigation methods by considering different groups—before the discrete Fourier transform (pre-DFT), after the discrete Fourier transform (post-DFT), the least square-based (LS-based), and other methods. Through a comprehensive review of the existing schemes, the effects of noise, harmonics, multiple DDCs (MDDCs), and off-nominal frequency (ONF) on the accuracy of DDC estimation, were recognized. A detailed discussion (along with some simulation results) are presented to address the main advantages/disadvantages of the past studies. Finally, this paper presents a few suggestions for future researchers, for researchers to investigate more implementable solutions in this field. [ABSTRACT FROM AUTHOR]