Search

Newborns' eyes and brains are prone to oxidative stress. Lutein has antioxidant properties and is the main component of macular pigment essential for protecting the retina, but has low bioavailability, thereby limiting its potential as a nutritional supplement. Oil-in-water emulsions have been used as lutein delivery systems. In particular, octenylsuccinated (OS) starch is a biopolymer-derived emulsifier safe to use in infant foods, while exhibiting superior emulsifying capacity. This study determined the effects of an OS starch-stabilized lutein emulsion on lutein bioavailability in Sprague-Dawley neonatal rats. In an acute study, 10-day-old pups received a single oral dose of free lutein or lutein emulsion, with subsequent blood sampling over 24 h to analyze pharmacokinetics. The lutein emulsion group had a 2.12- and 1.91-fold higher maximum serum lutein concentration and area under the curve, respectively, compared to the free lutein group. In two daily dosing studies, oral lutein was given from postnatal day 5 to 18. Blood and tissue lutein concentrations were measured. The results indicated that the daily intake of lutein emulsion led to a higher lutein concentration in circulation and key tissues compared to free lutein. The OS starch-stabilized emulsion could be an effective and safe lutein delivery system for newborns. [ABSTRACT FROM AUTHOR]

Carbon nanotubes (CNTs) and graphene have commonly been applied as the sensitive layer of strain sensors. However, the buckling deformation of CNTs and the crack generation of graphene usually leads to an unsatisfactory strain sensing performance. In this work, we developed a universal strategy to prepare welded CNT–graphene hybrids with tunable compositions and a tunable bonding strength between components by the in situ reduction of CNT–graphene oxide (GO) hybrid by thermal annealing. The stiffness of the hybrid film could be tailored by both initial CNT/GO dosage and annealing temperature, through which its electromechanical behaviors could also be defined. The strain sensor based on the CNT–graphene hybrid could be applied to collect epidermal bio-signals by both capturing the faint skin deformation from wrist pulse and recording the large deformations from joint bending, which has great potential in health monitoring, motion sensing and human–machine interfacing. [ABSTRACT FROM AUTHOR]

Metal chalcogenides are primarily used for thermoelectric applications due to their enormous potential to convert waste heat into valuable energy. Several studies focused on single or dual aliovalent doping techniques to enhance thermoelectric properties in semiconductor materials; however, these dopants enhance one property while deteriorating others due to the interdependency of these properties or may render the host material toxic. Therefore, a strategic doping approach is vital to harness the full potential of doping to improve the efficiency of thermoelectric generation while restoring the base material eco-friendly. Here, we report a well-designed counter-doped eco-friendly nanomaterial system (~70 nm) using both isovalent (cerium) and aliovalent (cobalt) in a Bi2Se3 system for enhancing energy conversion efficiency. Substituting cerium for bismuth simultaneously enhances the Seebeck coefficient and electrical conductivity via ionized impurity minimization. The boost in the average electronegativity offered by the self-doped transitional metal cobalt leads to an improvement in the degree of delocalization of the valence electrons. Hence, the new energy state around the Fermi energy serving as electron feed to the conduction band coherently improves the density of the state of conducting electrons. The resulting high power factor and low thermal conductivity contributed to the remarkable improvement in the figure of merit (zT = 0.55) at 473 K for an optimized doping concentration of 0.01 at. %. sample, and a significant nanoparticle size reduction from 400 nm to ~70 nm, making the highly performing materials in this study ( B i 2 − x C e x C o 2 x 3 S e 3 ) an excellent thermoelectric generator. The results presented here are higher than several Bi2Se3-based materials already reported. [ABSTRACT FROM AUTHOR]

Vitamin D plays a significant role in the physiological functions of the human body. However, the application of vitamin D in functional foods is limited due to its sensitivity to light and oxygen. Therefore, in this study, we developed an effective method to protect vitamin D by encapsulating it in amylose. In detail, vitamin D was encapsulated by amylose inclusion complex, followed by structural characterization and evaluation of its stability and release properties. The results of X−ray diffraction, differential scanning calorimetry, and Fourier transform infrared spectroscopy showed that vitamin D was successfully encapsulated in the amylose inclusion complex, and the loading capacity was 1.96% ± 0.02%. The photostability and thermal stability of vitamin D after encapsulation was increased by 59% and 28%, respectively. In addition, in vitro simulated digestion showed that vitamin D was protected through the simulated gastric environment and can be released gradually in the simulated intestinal fluid, implying its improved bioaccessibility. Our findings provide a practical strategy for the development of functional foods based on vitamin D. [ABSTRACT FROM AUTHOR]

This study demonstrates the fabrication of κ-carrageenan fibers by a wet-spinning method and discusses three important spinning parameters: coagulation bath composition, spinning rate and post-spinning mechanical drawing. The as-spun fiber diameter decreased with KCl and ethanol concentration in the coagulation bath. In general, the ultimate tensile stress and elongation at break both increased for KCl concentration from 0.1 to 0.5 M with and without ethanol, with no significant change above 0.5 M. Spinning rate affected the dope flow and thus the polymer orientation (apparent viscosity) and fiber morphology. At spinning rates between 0.25 mL/min and 0.33 mL/min, the fiber diameter reached a minimum and the fiber surface was smooth. Both an increase and decrease from this spinning rate range increased the fiber diameter and roughness of the fiber surface. Post-spinning drawing of the fiber resulted in even smaller fiber diameter. [ABSTRACT FROM AUTHOR]

Solar thermal techniques provide a promising method for the direct conversion of solar energy to thermal energy for applications, such as water desalination. To effectively realize the optimal potential of solar thermal conversion, it is desirable to construct an assembly with localized heating. Specifically, photoactive semiconducting nanoparticles, when utilized as independent light absorbers, have successfully demonstrated the ability to increase solar vapor efficiency. Additionally, bio-based fibers have shown low thermal conductive photocorrosion. In this work, cellulose acetate (CA) fibers were loaded with cadmium selenide (CdSe) nanoparticles to be employed for solar thermal conversion and then subsequently evaluated for both their resulting morphology and conversion potential and efficiency. Electrospinning was employed to fabricate the CdSe-loaded CA fibers by adjusting the CA/CdSe ratio for increased solar conversion efficiency. The microstructural and chemical composition of the CdSe-loaded CA fibers were characterized. Additionally, the optical sunlight absorption performance was evaluated, and it was demonstrated that the CdSe nanoparticles-loaded CA fibers have the potential to significantly improve solar energy absorption. The photothermal conversion under 1 sun (100 mW/cm2) demonstrated that the CdSe nanoparticles could increase the temperature up to 43 °C. The CdSe-loaded CA fibers were shown as a feasible and promising hybrid material for achieving efficient solar thermal conversion. [ABSTRACT FROM AUTHOR]

The circulating level of vitamin A (VA; retinol) was reported to be lower in obese adults. It is unknown if maternal obesity influences the VA status of offspring. The objective of the study was to determine the VA status and deposition of neonatal and weanling rats reared by mothers consuming a normal or high-fat diet (NFD or HFD) with or without supplemented VA. Pregnant Sprague-Dawley rats were randomized to an NFD or HFD with 2.6 mg/kg VA. Upon delivery, half of the rat mothers in the NFD or HFD cohort were switched to an NFD or HFD with supplemented VA at 129 mg/kg (NFD+VA and HFD+VA group). The other half remained on their original diet (NFD and HFD group). At postnatal day 14 (P14), P25, and P35, pups (n = 4 or 3/group/time) were euthanized. The total retinol concentration in the serum, liver, visceral white adipose tissue (WAT), and brown adipose tissue (BAT) was measured. At P14, the HFD+VA group showed a significantly lower serum VA than the NFD+VA group. At P25, both the VA concentration and total mass in the liver, WAT, and BAT were significantly higher in the HFD+VA than the NFD+VA group. At P35, the HFD group exhibited a significantly higher VA concentration and mass in the liver and BAT compared with the NFD group. In conclusion, maternal HFD consumption resulted in more VA accumulation in storage organs in neonatal and/or weanling rats, which potentially compromised the availability of VA in circulation, especially under the VA-supplemented condition. [ABSTRACT FROM AUTHOR]