Search

In this study, we investigate the changes in the crystalline structure of MBE-deposited SrTiO3 layers on Si with different deviations from Sr/Ti stoichiometry as deposited but also after annealing at high temperatures (>600 °C). We show that as-grown 15 nm thick non-stochiometric SrTiO3 layers present surprisingly lower FWHM values of the (002) omega diffraction peak compared to fully stoichiometric layers of similar thickness. This can misleadingly point to superior crystalline quality of such non-stochiometric layers. However, thermal post-deposition anneals of these layers at temperatures up to 850 °C in oxygen show strong detrimental effects on the crystalline structure, surface and interface with the Si (001) substrate. On the contrary, the post-deposition anneals applied to the stoichiometric samples strongly improve the physical, optical and electrical properties of the epitaxial SrTiO3 thin films. [ABSTRACT FROM AUTHOR]

In this work, we report on wet-chemical defect revealing in InP fin structures relevant for device manufacturing. Both HCl and HBr solutions were explored using bulk InP as a reference. A distinct difference in pit morphology was observed between the two acids, attributed to an anisotropy in step edge reactivity. The morphology of the etch pits in bulk InP suggests that the dislocations are oriented mainly perpendicular to the surface. By studying the influence of the acid concentration on the InP fin recess in nanoscale trenches, it was found that aqueous HCl solution was most suitable for revealing defects. Planar defects in InP fin structures grown by the aspect ratio trapping technique could be visualized as characteristic shallow grooves approximately one nanometer deep. It is challenging to reveal defects in wide-field InP fins. In these structures, dislocations also reach the surface next to stack faults or twinning planes. Due to the inclined nature, dislocation-related pits are only a few atomic layers deep. Extending the pits is limited by the high reactivity of the fin sides and the strong surface roughening during etching. The process window for revealing wet-chemical defects in InP fins is limited. [ABSTRACT FROM AUTHOR]