Search

For operation as power amplifiers in RF applications, high electron mobility transistor (HEMT) structures are subjected to a range of bias conditions, applied at both the gate and drain terminals, as the device is biased from the OFF- to ON-state conditions. The stability of the device threshold voltage (Vt) condition is imperative from a circuit-design perspective and is the focus of this study, where stresses in both the ON and OFF states are explored. We see rapid positive threshold voltage increases under negative bias stress and subsequent recovery (i.e., Vt reduces), whereas conversely, we see a negative Vt shift under positive stress and Vt increase during the subsequent relaxation phase. These effects are correlated with the thickness of the GaN layer and ultimately result from the deep carbon-acceptor levels in the C-GaN back barrier incorporated to screen the buffer between the silicon substrate and the epitaxially grown GaN layer. Methods to mitigate this effect are explored, and the consequences are discussed. [ABSTRACT FROM AUTHOR]

The temperature dependent carrier transport characteristics of n-type gate-all-around nanowire field effect transistors (GAA NW-FET) on bulk silicon are experimentally compared to bulk fin field effect transistors (FinFET) over a wide range of temperatures (25–125 °C). A similar temperature dependence of threshold voltage (VTH) and subthreshold swing (SS) is observed for both devices. However, effective mobility (μeff) shows significant differences of temperature dependence between GAA NW-FET and FinFET at a high gate effective field. At weak Ninv (= 5 × 1012 cm2/V∙s), both GAA NW-FET and FinFET are mainly limited by phonon scattering in μeff. On the other hand, at strong Ninv (= 1.5 × 1013 cm2/V∙s), GAA NW-FET shows 10 times higher dμeff/dT and 1.6 times smaller mobility degradation coefficient (α) than FinFET. GAA NW-FET is less limited by surface roughness scattering, but FinFET is relatively more limited by surface roughness scattering in carrier transport. [ABSTRACT FROM AUTHOR]

Nano-ridge engineering (NRE) is a novel method to monolithically integrate III–V devices on a 300 mm Si platform. In this work, NRE is applied to InGaP/GaAs heterojunction bipolar transistors (HBTs), enabling hybrid III-V/CMOS technology for RF applications. The NRE HBT stacks were grown by metal-organic vapor-phase epitaxy on 300 mm Si (001) wafers with a double trench-patterned oxide template, in an industrial deposition chamber. Aspect ratio trapping in the narrow bottom part of a trench results in a threading dislocation density below 106∙cm−2 in the device layers in the wide upper part of that trench. NRE is used to create larger area NRs with a flat (001) surface, suitable for HBT device fabrication. Transmission electron microscopy inspection of the HBT stacks revealed restricted twin formation after the InGaP emitter layer contacts the oxide sidewall. Several structures, with varying InGaP growth conditions, were made, to further study this phenomenon. HBT devices—consisting of several nano-ridges in parallel—were processed for DC and RF characterization. A maximum DC gain of 112 was obtained and a cut-off frequency ft of ~17 GHz was achieved. These results show the potential of NRE III–V devices for hybrid III–V/CMOS technology for emerging RF applications. [ABSTRACT FROM AUTHOR]