Search

This study investigates how varying cell size affects the mechanical behaviour of photopolymer Triply Periodic Minimal Surfaces (TPMS) under different deformation rates. Diamond, Gyroid, and Primitive TPMS structures with spatially graded cell sizes were tested. Quasi-static experiments measured boundary forces, representing material behaviour, inertia, and deformation mechanisms. Separate studies explored the base material's behaviour and its response to strain rate, revealing a strength increase with rising strain rate. Ten compression tests identified a critical strain rate of 0.7 s -1 for "Grey Pro" material, indicating a shift in failure susceptibility. X-ray tomography, camera recording, and image correlation techniques observed cell connectivity and non-uniform deformation in TPMS structures. Regions exceeding the critical rate fractured earlier. In Primitive structures, stiffness differences caused collapse after densification of smaller cells at lower rates. The study found increasing collapse initiation stress, plateau stress, densification strain, and specific energy absorption with higher deformation rates below the critical rate for all TPMS structures. However, cell-size graded Primitive structures showed a significant reduction in plateau and specific energy absorption at a 500 mm/min rate.

The paper gives a detailed review of the approaches adopted for embedding information into/onto additively manufactured parts. The primary purpose of this paper is to review all the techniques adopted for embedding information, highlight notable trends and improvements in these works, and provide design and manufacturing pipelines to realize most of these works. It classifies these approaches into four different categories and summarizes the works carried out in each field. It also compares all the results in textual and tabular forms and then gives a detailed conclusion of the best works in terms of application and effectiveness. The four categories discussed are 3D QR codes, 3D watermarking, steganography and nonclassified methods. Lastly, it discusses the future extensions and potential improvements in the field of embedding information, while exploring manufacturing technologies.