Search

Featured Application: The research provides a theoretical reference for transformer closing-control strategies, in which the superposition effect decreases as the reclosing interval increases. When a transformer suffers a permanent fault, it will suffer a short-circuit impulse again after reclosing. If the previous vibration of the winding is not attenuated completely and the winding is subjected to a secondary impulse within a short time, the secondary vibration response will have a superposition. The aim of this study was to analyze the effect of the anti-short-circuit ability of operational transformers subjected to a secondary short-circuit current impulse. In this paper, a model is established for calculating axial vibration in transformer windings and effects on the vibration response of windings under different closing phase angles and short-circuit intervals are analyzed. The results show that the vibration acceleration of windings is a V-shaped variation at phase angles from 0° to 180°, reaching the maximum values at 0° and 180° and reaching the minimum value at 90°. When the transformer recloses on a permanent short circuit, due to the superposition effect, the vibration acceleration amplitude of the secondary impulse will be greater than that of the primary impulse, but as the reclosing interval increases, the superposition effect decreases continuously. When the interval is 600 ms, the superposition effect for the vibration acceleration of the secondary impulse attenuates to 83.3%. The superposition effect is not significant after 600 ms. The research provides a theoretical reference for transformer closing-control strategies. [ABSTRACT FROM AUTHOR]

Soil erosion is a major form of land degradation, especially in agroecosystems, which has been effectively controlled by vegetation restoration. However, the interactive role of erosion and cropland revegetation on soil enzyme activities and microbial nutrient limitations is less understood. To address this issue, we examined carbon (C), nitrogen (N), and phosphorus (P) in bulk soils and microbial biomass, enzyme activities, and microbial nutrient limitations in the 0–200 cm soils in eroded and deposited landscapes occupied by cropland, revegetated forest, and grassland. The results showed that the activities of C-, N-, and P-acquiring enzymes were larger in the deposited landscape than in the eroded landscape for 0–20 cm soils in forest and grassland but not in cropland. Microbial metabolism was co-limited by N and P, and the threshold element ratio (TERL) indicated that P was the most limiting factor. Microbial N limitation was lower in the deposited than the eroded zone, especially in surface soils in revegetated forest and grassland. The TERL value was larger at the deposited than at the eroded zone, and a greater difference was found in the surface soils of forest and grassland. Microbial nutrient limitations were mostly explained by C/P and N/P. Conclusively, the deposited areas were characterized by ameliorated enzyme activities, decreased microbial N limitation but relatively strengthened microbial P limitation compared to the eroded area, and such variations existed in the revegetated forest and grassland but not in the cropland, which thus contributes to a better understanding of C and nutrient cycling for agroecosystems and revegetation ecosystems in eroded environments. [ABSTRACT FROM AUTHOR]

The crosslinked polyethylene (XLPE) cable safety is affected by environmental factors and artificial defects during operation. This work proposes an improved locating method based on broadband impedance spectrum (BIS) to locate local defects in XLPE cables. The calculation process of the algorithm has been analyzed. The selection of the incident Gaussian signal and the peak recognition method have been discussed, where the pulse width of the Gaussian signal was found to be determined primarily by the upper limit frequency of the traveling wave transmitting in the cable. The centroid and function fitting methods were established to reduce the peak recognition error caused by the test sampling rate. This work verified the accuracy of the algorithm through experiments. A vector network analyzer (VNA) was used to test the BIS of the cable. A 20 m-long cable containing abrasion and an inserted nail with different depths was measured in the BIS test. It was found that the abrasion and the nail could be located. The locating deviation of abrasion was within ±1%, and the centroid and function fitting methods could effectively reduce the locating deviation. The locating deviation was within ±1% when the depth of the nail inserted into the cable accounted for less than 50% of the insulation thickness. When the depth exceeded 75% of the insulation thickness, the deviation of each method was more significant, and the maximum absolute value of the deviation was 4%. [ABSTRACT FROM AUTHOR]

Electrical treeing is one of the main causes of crosslinked polyethylene (XLPE) cable failure. The current methods for locating electrical trees are mainly based on the partial discharge (PD) signal. However, PD signals are easily attenuated in the long cable and the PD test voltage may cause damage to the insulation. This work proposes an improved broadband impedance spectrum (BIS) method to locate electrical trees in XLPE cable. A mathematical model of a long cable containing local electrical tree degradation is established. The Gaussian signal is chosen as the simulated incident signal to reduce the spectral leakage. The location spectrum is obtained by multiplying the frequency domain function of the single-ended reflection coefficient and the Gaussian pulse. It has been found that the location spectrum of the local capacitance change can be characterized as a typical double-peak waveform and the spectrum of the local conductance change can be regarded as a typical single-peak waveform. Electrical tree experiments at different temperatures were carried out to initiate different types of electrical trees. A vector network analyzer (VNA) was used to test the high frequency capacitance characteristics in the treeing process. The location spectra of the 20 m long cable containing different types of electrical trees was calculated by the improved location algorithm. The results show that the location error of local electrical tree degradation is less than 3%. The capacitance of the sliced sample decreases with treeing time. The effect of the bush-pine tree on capacitance parameters is greater than that of the branch-pine tree. A typical double-peak is found in the bush-pine tree location spectrum and a single-peak is found in the branch-pine tree spectrum. [ABSTRACT FROM AUTHOR]

The noise caused by rail corrugation seriously affects the operation quality of metro vehicles. In this work, the rail corrugation, interior noise and wheel–rail noise of a metro line were tested, and the test results were compared with those after two kinds of treatments. The results show that rail corrugation is the main cause of the abnormal interior noise. The interior noise in many sections exceeds the limit, where clear rail corrugations from 31.5~63 mm are found. When the train passes through the rail corrugation section, the interior noise shows a clear increase, and the maximum increase is higher than 25 dB(A). After increasing the lateral stiffness of the track and rail grinding, the interior noise is reduced by 11.4 dB(A). After a long renovation time, the interior noise is effectively equal to that when the renovation was completed. The research results of this work can provide a reference for rail corrugation treatment and noise control. [ABSTRACT FROM AUTHOR]