Search

Anaerobic digestion of waste-activated sludge (WAS) towards biogas recovery is constrained by the limited hydrolysis and inhibited acetogenesis steps that hinder subsequent energy recovery. This study employed Fe(VI)/S(IV) oxidation to enhance the WAS solubilization and coupled it with the syntrophic interaction of hydrogen-producing acetogen (HPA) and sulfate-reducing bacteria (SRB) to stimulate the successive procedure towards methane production. Results showed that the dosage ratio of HPA-SRB to WAS (H-S-W) with 1:1:50 outperformed with the highest methane production potential (11.63 ± 1.87 mL CH4/(g VSS·d). Meanwhile, the efficient and sequential process from acetogenesis to methanogenesis stimulated by HPA-SRB was evidenced by a significant decrease of 30.2% in the acetate concentration. The microbial community structure further manifested the crucial role of HPA-SRB with increased abundance of Desulfobulbus (2.07%), Syntrophomonas (1.24%) and Smithella (1.63%), which stimulated acetophilic methanogen boost with Methanobacterium dominating with 77.51% in H-S-W100. Furthermore, the positive syntrophic relationships among HPA-SRB and acetophilic methanogens towards methane production were confirmed via molecular ecological network and canonical correspondence analysis. This study highlighted the syntrophic cooperation of the mixed consortia of HPA and SRB on methane production based on Fe(VI)/S(IV) pretreatment and provided the theoretical and technical basis for the potential implementation of novel methanogenesis technology for WAS treatment. [ABSTRACT FROM AUTHOR]

Maximizing the internal carbon sources in raw wastewater was found to be an alternative option to alleviate the financial burden in external carbon sources (ECS) addition to the biological nutrient removal (BNR) process. Based on previous studies on particulate recovery via fine-sieving technologies, alkali pretreatment was used to improve the short-chain fatty acid (SCFA) production from the fine-sieving fractions (FSF). Hydrolysis performance and methane production were monitored to evaluate the reasons for the SCFA boost. Besides, the microbial community structure was evaluated by high-throughput sequencing. Furthermore, mass balance and financial benefits were preliminarily estimated. The results showed that alkali pretreatment effectively promoted the generation of SCFAs with 234 mg/g volatile suspended solids (VSS), almost double that of the control test. This was partially attributed to the efficient hydrolysis, with soluble polysaccharides and protein increased by 2.1 and 1.2 times compared to that of the control, respectively. Inhibition of methanogens was also devoted to the accumulation of SCFAs, with no methane production until 150 h at high pH value. Finally, a preliminary evaluation revealed that 44.51 kg/d SCFAs could be supplied as the electron donor for denitrification, significantly reducing the cost in ECS addition for most wastewater treatment plants (WWTPs) with carbon insufficiency. [ABSTRACT FROM AUTHOR]

A novel starch stabilized Mg/Al layered Double hydroxides (S-LDHs) was prepared in a facile approach and its fluoride ion removal performance was developed. Characterization of S-LDHs was employed by using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), and particle size distribution. The adsorption property was studied through the assessment of the adsorption isotherms, kinetic models, thermal dynamics, and pH influence. The result shows that a low loading of starch of 10 mg onto layered double hydroxides (LDHs) could obviously improve the fluoride removal rate. The S-LDHs had three times higher the adsorption capacity to fluoride than that of Mg/Al LDHs to fluoride. The particle size was smaller and the particle size distribution was narrower for S-LDHs than that for Mg/Al LDHs. The Langmuir adsorption isotherm model and pseudo-second-order kinetic model fitted well with the experimental data. In thermodynamic parameters, the enthalpy (ΔH0) value was 35.63 kJ·mol−1 and the entropy (ΔS0) value was 0.0806 kJ·mol−1K−1. The values of ΔG0 were negative, implying the adsorption process is spontaneous. S-LDHs reveals stable adsorption property in a wide pH range from 3 to 9. The mechanism for fluoride adsorption on S-LDHs included surface adsorption and interaction ion exchange. [ABSTRACT FROM AUTHOR]