Search

A highly sustainable method for the preparation of supported iron oxide and copper nanoparticles (NPs) on a biomass-derived carbon by solvent-free mechanochemical process is reported. In-situ mechanochemically obtained extracts from orange peel could behave as a green reducing agent, allowing the formation of Cu metal nanoparticles as well as generating a magnetic phase (magnetite) in the systems via partial Fe3+ reduction. At the same time, orange peel residues also served as template and carbon source, adding oxygen functionalities, which were found to benefit the catalytic performance of mechanochemically synthesized nanomaterials. The series of magnetic Cu-Fe@OP were tested in the oxidation of trans-ferulic acid towards vanillin, remarkably revealing a maximum vanillin yield of 82% for the sample treated at 200 °C.

We report a new class of polyacrylonitrile (PAN)-based Co-N-doped carbon materials that can act as suitable catalyst for oxygen evolution reactions (OER). Different Co loadings were mechanochemically added into post-consumed PAN fibers. Subsequently, the samples were treated at 300 °C under air (PAN-A) or nitrogen (PAN-N) atmosphere to promote simultaneously the Co3O4 species and PAN cyclization. The resulting electrocatalysts were fully characterized and analyzed by X-ray diffraction (XRD) and photoelectron spectroscopy (XPS), transmission (TEM) and scanning electron (SEM) microscopies, as well as nitrogen porosimetry. The catalytic performance of the Co-N-doped carbon nanomaterials were tested for OER in alkaline environments. Cobalt-doped PAN-A samples showed worse OER electrocatalytic performance than their homologous PAN-N ones. The PAN-N/3% Co catalyst exhibited the lowest OER overpotential (460 mV) among all the Co-N-doped carbon nanocomposites, reaching 10 mA/cm2. This work provides in-depth insights on the electrocatalytic performance of metal-doped carbon nanomaterials for OER.

In this study, the co-synthesis of TiO2 and Cu metallic nanoparticles obtained via one-pot cost-efficient hydrothermal process has been addressed. Different nanocatalysts with Cu contents were characterized by X-ray diffraction, nitrogen porosimetry, scanning electron microscopy, and transmission electron microscopy. The TiO2 and Cu metallic nanoparticles were synthesized with copper loading up to one (Cu/Ti atomic ratio). Synthesized catalysts exhibited pore sizes in the mesoporous range and high surface areas above 150 m2/g. The particle size for TiO2 presented a homogeneous distribution of approximately 8 nm, moreover, Cu nanoparticles varied from 12 to >100 nm depending on the metal loading. The nanostructured materials were successfully tested in the conversion of trans-ferulic acid into vanillin under sustainable conditions, achieving the best performance for 0.3 Cu/Ti atomic ratio (70% vanillin yield).