Search

Anaerobic digestion has the potential to convert organic waste materials into valuable energy. At the same time, using press water from biomass materials for energy generation while taking advantage of the resulting cake for other purposes is an emerging approach. Therefore, this study aimed to investigate the residual potential expected from a typical biogas feedstock after it has been mechanically separated into liquid and solid phases. Hence, in this study, the rumen contents of ruminants (cow, goat, and sheep) and their proportionate ratios were obtained from an abattoir in Ghana. Resource characterization of the waste samples was carried out in the central laboratory of the HFR, Germany. Anaerobic batch tests for biogas (biomethane) yield determination were set up using the Hohenheim Biogas Yield Test (HBT). The inoculum used was obtained from an inoculum production unit at the Hohenheim University biogas laboratory. The trial involved two different forms of the sample: mixture of rumen contents, press water, and inoculum, each in four (4) replicates. The trial was carried out at a mesophilic temperature of 37 °C. Results obtained over a seventy (70) day period were transformed into biogas yields. Overall, the results show that the current contents are suitable for biogas generation as an option as opposed to the current form of disposal at a refuse dump. However, using these mixtures in their original forms is more technically viable than using press water without further treatment.

Silphium perfoliatum, an energy crop with a high fiber content but low concentrations of fermentable carbohydrates, presents challenges for complete fermentation in biogas production. To overcome this, a bioeconomic approach proposes the use of the fibers for paper and board production, which requires high-quality silage with minimal butyric acid, which affects the marketability of the fibers. This study aims to optimize the silaging process of Silphium perfoliatum by investigating the effects of harvest date, bacterial cultures and additives on fermentation results. Laboratory experiments were conducted to evaluate the effect of three harvest dates on fermentation acid composition, with a focus on increasing lactic acid production to inhibit butyric acid formation. Results indicate that an early harvest date (early September) is critical for achieving stable fermentation and minimizing ensiling losses. The addition of sugar-rich additives, such as syrup, was found to be essential, especially for later harvest dates. Despite these interventions, a late harvest (early November) consistently resulted in suboptimal fermentation. The results suggest that optimizing harvest timing and incorporating appropriate additives are key strategies for producing high quality silage and ensuring the suitability of Silphium perfoliatum fibers for industrial applications.

The global demand for packaging materials and energy is constantly increasing, requiring the exploration of new concepts. In this work, we presented a bioeconomic concept that uses steam explosion and phase separation to simultaneously generate fibers for the packaging industry and biogas substrate for the energy sector. The concept focused on fiber-rich residues and fiber-rich ecological energy crops from agriculture. Feasibility of the concept in the laboratory using feedstocks, including Sylvatic silphia silage, Nettle silage, Miscanthus, Apple pomace, Alfalfa stalks, and Flax shives was confirmed. Our results showed that we were able to separate up to 26.2% of the methane potential while always extracting a smaller percentage of up to 17.3% of organic dry matter (ODM). Specific methane yields of 297–486 LCH4 kgODM−1 in the liquid and 100–286 LCH4 kgODM−1 in the solid phase were obtained. The solid phases had high water absorption capacities of 216–504% due to the steam explosion, while the particle size was not significantly affected. The concept showed high potential, especially for undried feedstock.

Sargassum muticum (SM) is an invasive macroalgal species seasonally occurring in large quantities. While generally suitable for anaerobic digestion, recent studies resulted in low specific methane yields (SMYs), presumably due to salt, polyphenol, and high fiber contents of this marine biomass. In this study, the specific biogas yield (SBY) and SMY of SM alone as well as in co-digestion with wheat straw (WS) were investigated in batch tests at process temperatures of 44 ± 1.4 °C with a retention time of approx. 40 d. The pretreatment variants of SM were examined with regard to desalination and disintegration to potentially improve digestibility and to enhance the overall performance in anaerobic digestion. A sole mechanical treatment (pressing) and a thermo-mechanical treatment (heating and pressing) were tested. Batch assays showed that pressing increased the SMY by 15.1% whereas heating and pressing decreased the SMY by 15.7% compared to the untreated variant (87.64 ± 8.72 mL/gVS). Both anaerobic digestion experiments generally showed that co-digestion with WS can be recommended for SM, but the observed SBY and SMY were still similar to those of other studies in which SM was not pretreated. The mechanical pretreatment of SM, however, offers the potential to enhance the SMY in the anaerobic digestion of SM with WS, but further research is necessary to identify the optimum upgrading approaches since the overall SMY of SM is relatively low compared to other substrates that are commonly used in anaerobic digestion. In addition to anaerobic digestion, SM as an already available biomass could also be of interest for further utilization approaches such as fiber production.

Hydrothermal treatment (HTT) offers the potential to upgrade low-value biomass such as digestate (DG) or forest residue (FR) by producing solids and liquids for material use or energetic utilization. In this study, microwave-assisted HTT experiments with DG and FR as feedstocks were executed at different temperatures (130, 150, 170 °C) and with different holding times (30, 60, 90 min) to determine the influences on product properties (ash and elemental concentrations, calorific values and chemical compounds). In general, DG and FR reacted differently to HTT. For the DG solids, for instance, the ash concentration was reduced to 8.68%DM at 130 °C (initially 27.67%DM), and the higher heating value increased from 16.55 MJ/kgDM to 20.82 MJ/kgDM at 170 °C, while the FR solids were affected only marginally. Elements with importance for emissions in combustion were leached out in both HTT solids. The DG and FR liquids contained different chemical compounds, and the temperature or holding time affected their formation. Depending on the designated application of HTT, less severe conditions can deliver better results. It was demonstrated that different low-temperature HTT conditions already induce strong changes in the product qualities of DG and FR. Optimized interactions between process parameters (temperature, holding time and feedstock) might lead to better cost–benefit effects in HTT.

Technical drying of harvested wood fuels is heat and energy consuming, while natural pre-drying in the forest, e.g., in stacks or storage piles, is accompanied by energy losses through natural degradation processes. Dewatering of energy wood by mechanical pressing is an innovative method to reduce the moisture content prior to thermal drying while producing press waters (PW, also referred to as wood juice) as a by-product. To date, the characteristics and utilization potentials of PW are largely unknown. In this study, three different spruce- and poplar-based PW were analyzed for their characteristics such as dry matter (DM), organic dry matter (oDM) concentration, pH-value, element concentration or chemical compounds. Additionally, they were used for anaerobic digestion (AD) experiments with digested sewage sludge (DSS) serving as inoculum. The fresh matter-based DM concentrations of the PW were between 0.4 and 3.2%, while oDM concentrations were between 87 and 89%DM. The spruce-based PW were characterized by lower pH-values of approx. 4.4, while the poplar-based PW was measured at pH 8. In the AD experiments, DSS alone (blank variant) achieved a specific methane yield of 95 ± 26 mL/goDM, while the mixture of spruce-based PW and DSS achieved up to 160 ± 12 mL/goDM, respectively. With further research, PW from wood fuel preparation offer the potential to be a suitable co-substrate or supplement for AD processes.

This study evaluated the CO2 sequestration potential with combustion ashes in the aqueous phase. The aim was to provide a cost-effective carbon sequestration method for combustion unit operators (flue gas cleaning) or biogas producers (biogas upgrading). Therefore, two separate test series were executed to identify the carbonation efficiency (CE) of bottom wood ash (1) at different mixing ratios with water in batch experiments and (2) under dynamic flow conditions. It was furthermore evaluated whether subsequent use of the carbonated wood ash for soil amendment could be possible and whether the process water could be passed into the sewage. The batch test series showed that different mixing ratios of wood ash and water had an influence on the CE. The flow series showed that the mean CE varied between approximately 14% and 17%. Thus, the ash proved to be suitable for carbonation processes. The process water was dischargeable, and the carbonated wood ash has potential for chalking, as no legal thresholds were exceeded. Therefore, wood ash carbonation could be used as a low-tech CO2 sequestration technology. Compared to existing energy consuming and cost intensive carbon capture and storage technologies, sequestration with ash could be beneficial, as it represents a low-tech approach.

In comparison to lignocellulosic biomass, which is suitable for thermo-chemical valorization, the organic fraction of municipal solid waste (OFMSW) is mainly treated via composting or anaerobic digestion (AD). An efficient utilization of OFMSW is difficult due to variations in its composition. Based on the characteristics of OFMSW, hydrothermal treatment (HTT) experiments at temperatures < 200 °C as an alternative OFMSW-processing were evaluated in this study. The raw OFMSW was characterized with a dry matter (DM)-based organic dry matter (oDM) content of 77.88 ± 1.37 %DM and a higher heating value (HHV) of 15,417 ± 1258 J/gDM. Through HTT at 150, 170 and 185 °C, the oDM contents as well as H/C and O/C ratios were lowered while the HHV increased up to 16,716 ± 257 J/gDM. HTT led to improved fuel properties concerning ash melting, corrosion stress and emission behavior. Negative consequences of the HTT process were higher contents of ash in the biochar as well as accumulated heavy metals. In the sense of a bioeconomy, it could be beneficial to first convert raw OFMSW into CH4 through AD followed by HTT of the AD-digestate for the generation of solid fuels and liquid products. This could increase the overall utilization efficiency of OFMSW.

This study evaluates the anaerobic digestion (AD) of the organic fraction of municipal solid waste (OFMSW) and digested sewage sludge (DSS) at lowered temperatures. AD batch tests for CH4 yield determination were carried out with DSS as inoculum between 23 and 40 °C. All results were related to organic dry matter and calculated for standard conditions (1013 hPa, 0 °C). The AD experiments at 40 °C and at 35 °C delivered specific CH4 yields of 325 ± 6 mL/g and 268 ± 27 mL/g for OFMSW alone. At lower temperatures, specific CH4 yields of 364 ± 25 mL/g (25 °C) and 172 ± 21 mL/g (23 °C) were reached. AD at 25 °C could be beneficial regarding energy input (heating costs) and energy output (CH4 yield). Plant operators could increase AD efficiencies by avoiding heating costs. The co-digestion of OFMSW together with DSS could lead to further synergies such as better exploitation of the energy potentials of DSS, but the digestate utilization could become problematic due to hygienic requirements. Efficiency potentials through lowered operating temperatures are limited. In further research, lowered process temperatures could be applied in the AD of energy crops due to large numbers of existing plants.