Search

The elastic modulus is a key factor influencing the applications of implant materials because of the weakening effect of stress shielding. Ti and its alloys are good potential implant materials thanks to their low elastic modulus and fine biocompatibility. The addition of alloying elements into pure Ti and Ti alloys is the basic way to further decrease the elastic modulus whilst simultaneously enhancing strength, wearability, and corrosion resistance, for example. Finding the relationship between the composition and elastic modulus can greatly promote the development of Ti alloys with a low modulus for implant applications. In the current work, we investigated the elastic modulus of TiZrTa alloys with scores of compositions by using the high-throughput diffusion couple method, nanoindentation, and an electron probe micro-analysis. The relationship between the elastic modulus and the composition of the TiZrTa alloys was obtained. The average valence electron theory was employed to make clear the variation between the elastic modulus and the composition. Finally, the composition range formulae of TiZrTa alloys likely to have a low modulus were established by combining our data and previous results. These findings are helpful in developing new Ti alloys with a low modulus and also help to further understand the alloying theory.

Anodization is performed on the Ti-30Zr-5Al-3V (TZ30) alloy to improve its surface performance. X-ray diffractometer (XRD), scanning electron microscopy (SEM), and Olympus microscope are used to determine the phase constitution, morphology, and thickness of the anodization film (AOF). Tribological tests and electrochemical corrosion experiments are carried out to measure, respectively, the wear behavior and corrosion resistance of AOFs in simulated body fluid (SBF) solution. The microstructure characteristic of the AOF anodized at low voltage (20 V) is composed of compact and loose regions. As the applied voltage increases to 60 V, the compact regions transform progressively into loose regions, and then grow into nanotube regions. Besides, an increase in thickness of the AOF from 8.6 ± 4.61 μm to 20.7 ± 2.18 μm, and a gradual increase in surface microhardness from 364.6 ± 14.4 HV to 818.4 ± 19.3 HV, are also exhibited as the applied voltage increases from 20 V to 60 V. Specimens anodized at 40 V and 60 V have a low friction coefficient (~0.15) and wear rate (~2.2 mg/N/m) in the SBF solution. The enhanced wearability originates from the high hardness and various wear mechanisms. Potentiodynamic polarization curves suggest that the corrosion resistance in the SBF solution of all anodized specimens is greatly improved, thanks to the protection from the anodized TiO2 film.