Search

The photo-transferred optically stimulated luminescence (PTOSL) technique using Al2O3:C detectors has been suggested as a good option for ultraviolet (UV) radiation dosimetry. The objective of this work was to study the PTOSL response of Al2O3:C InLight detectors and the OSL microStar reader of Landauer. The parameters such as radiation pre-dose, optical treatment time and UV illumination time were determined. The detectors presented a satisfactory stimulus of PTOSL signals when they were subjected to a preconditioning procedure with gamma radiation (1 Gy pre-dose), 30 min of optical treatment (to empty the shallow traps) and 30 min of UV illumination from an artificial source.

Beta emitters are widely used in nuclear medicine for diagnostic and therapeutic purposes. The critical groups exposed to a radioactive patient include the staff, other patients and members of the public accompanying the patient. The aim of this work is to characterise thermoluminescent (TL) materials for the staff monitoring of nuclear medicine services that manipulate beta radiation solutions of (153)Sm. This study was performed using CaSO(4):Dy + Teflon pellets, produced at IPEN, with different dimensions. For the dosimetric characterisation, these TL dosemeters were exposed to gamma source ((60)Co) and to beta sealed sources ((90)Sr + (90)Y, (204)Tl and (147)Pm) and to a non-sealed source ((153)Sm). Results were obtained related to reproducibility, lower detection limits, calibration curves, angle and energy dependence of response. All tested materials show usefulness for monitoring of workers exposed to beta radiation.

The properties of the thermally stimulated exoelectron emission (TSEE) and thermoluminescent (TL) emission of topaz-glass composites were studied with the aim of using them as solid-state dosemeters. The TSEE response was studied as a function of radiation energy and as a function of absorbed dose. Topaz-glass composites presented a linear TL and TSEE response to dose within a range of 0.01-1 Gy. The topaz-glass composites presented higher TSEE peaks than topaz-Teflon pellets. In the dosimetry of radiotherapic fields normally the responses of the topaz-glass dosemeters are comparable to topaz-Teflon pellets. The results confirmed that these new dosemeters can be useful in monitoring the quality of the radiation sources. This dose mapping technique is particularly useful in investigating dose distribution throughout a planned target volume.

The dosimetric properties of sand from Brazilian beaches have shown to be useful for high-dose dosimetry. The thermoluminescent (TL) and electron paramagnetic resonance (EPR) techniques were utilised, and the sand samples were recently studied in relation to their main dosimetric properties. The EPR signal at g = 1.999 grows significantly in function of the absorbed dose, and the TL peaks appear at 110 and 170 degrees C. However, these sand samples present a post-irradiation thermal decay at room temperature, which is a problem for dosimetric procedures. In this study, sand samples have been studied in relation to different thermal treatments. Post-irradiation treatments were performed at 50 degrees C up to 230 degrees C.

The dosimetry of beta radiation is a difficult process especially because of the low penetration of beta particles in matter. The dosemeter utilised for this kind of procedure needs to approximate an ideal point-like detector: it should be as thin as possible, and its area should be small. The thermoluminescence dosemeters (TLDs) meet with these requirement properties. The aim of this work was to study the dosimetric characteristics of different TLDs to verify the possibility of their use for the calibration of 90Sr+90Y plane applicators. The response reproducibility, calibration curves, TL response as a function of the source-detector distance, the transmission factors and the linearity of the sample response were obtained for several types of dosimetric pellets.

Coloured glasses produced commercially by Cebracê, São Paulo, were analysed by the thermoluminescent (TL) method, to verify the possibility of their use as high-dose dosemeters or irradiation indicators in industrial areas, due to their easy handling and their low cost. The samples were exposed to different radiation doses, using the Gamma-Cell 220 system (60Co) of IPEN. The TL emission curves presented main peaks at 135, 150 and 145 degrees C in the bronze, brown and green glass samples, respectively. Calibration curves were obtained for the glasses between 50 Gy and 360 kGy. Reproducibility of TL response and the lower detection doses were determined for each kind of glass. All tested glasses showed their usefulness as irradiation indicators and as high-dose dosemeters.

A quality control program for X ray equipment used for conventional radiography and mammography requires the constancy check of the beam qualities in terms of the half-value layers. In this work, a special double-faced parallel-plate ionisation chamber was developed with inner electrodes of different materials, in a tandem system. Its application will be in quality control programs of diagnostic and mammography X ray equipment for confirmation of half-value layers previously determined by the conventional method. Moreover, the chamber also may be utilised for measurements of air kerma values (and air kerma rates) in X radiation fields used for conventional radiography and mammography. The chamber was studied in relation to the characteristics of saturation, ion collection efficiency, polarity effects, leakage current, and short-term stability. The energy dependence in response of each of the two faces of the chamber was determined over the conventional radiography and mammography X ray ranges (unattenuated beams). The different energy response of the two faces of the chamber allowed the formation of a tandem system useful for the constancy check of beam qualities.

A non-invasive calibration methodology of quality control instruments for diagnostic radiology was established and applied to different kinds of commercial kVp meters. The method uses the measurement of the spectrum endpoint as a reference. The results showed a variation of 10% between the responses of the instruments calibrated and the spectrometric system, a fact that demonstrates the need for instrument calibration.

A thermally stimulated exoelectron emission (TSEE) measuring system developed and constructed at IPEN was used to verify the feasibility of the use of Brazilian natural semi-precious stones, such as jasper. amethyst, agate (blue and rose) and quartz (rose and white) for gamma and X radiation detection. Its counting system consists of a 2pi windowless gas-flow proportional counter, and the heating system is formed by a temperature programmer that provides linear heating of the samples. The samples were tested in gamma and in X radiation beams and evaluated in relation to their main dosimetric characteristics, as TSEE glow curves, calibration curves and energy dependence. The TSEE results are compared with those of thermoluminescence. The results obtained show the usefulness of Brazilian natural stones as dosimetric materials, using the thermoluminescence and thermally stimulated exoelectron emission techniques.

The aim of the present work is to investigate the possibility of using the properties of the thermoluminescent emission (TL) of Brazilian natural topaz for dosimetric applications. Topaz is an aluminium fluorsilicate with general composition of Al2(SiO4)(F,OH)2 found with relative abundance in Brazil and in other parts of the world. Topaz from Santo Antonio do Jacinto, Minas Gerais. Brazil, was used in this work, in the form of pellets of topaz mixed with Teflon and composites made with topaz embedded in a glass matrix. The TL sensitivity was tested between 10(-4) and 10(4) Gy. The TL peak intensity increases with the dose before saturation, which occurs around 2 kGy. The peak intensity showed a strong dependence with radiation energy. The effect of visible light and the behaviour of the TL signals after successive irradiation-reading-annealing cycles are presented and discussed.

Glass samples were tested for use in high-dose dosimetry in radiation processing. The main dosimetric characteristics were determined: lower detection threshold, reproducibility, response to gamma radiation of 60Co and thermal decay at room temperature, with the use of a densitometer, spectrophotometer and thermoluminescence reader. The results show that this kind of material could be useful for dosimetry in several applications of ionising radiation, taking into account its thermal fading.

Commercial transparent glass has received attention in relation to its use as a gamma radiation detector. This kind of material presents a strong post-irradiation thermal decay at room temperature, which is a problem for high dose dosimetry purposes. This effect may be avoided by taking measurements always at the same time after irradiation of the glass samples. However, in this work effort has been given to this material characteristic, submitting the glass samples to different thermal treatments. The best results were obtained with a post-irradiation treatment at 130 degrees C during 10 min. This procedure seems to destroy the unstable entities responsible for the initial strong decay of the sample response, showing acceptable stability as a function of room temperature storage time.