Search

S -wave spectral amplitudes from 312 crustal earthquakes recorded at the Iranian National Broadband Seismic Network in the Alborz region between 2005 and 2017 are analysed in order to evaluate earthquake source parameters, path attenuation and site amplification functions using the non-parametric generalized inversion technique (GIT). We exploit a total number of 1117 seismograms with M L 3–5.6 in the frequency range 0.3–20 Hz. The evaluated non-parametric attenuation functions decay uniformly with distance for the entire frequency range and the estimated S -wave quality factor shows low Q values with relatively strong frequency dependence. We assume the omega-square source model to retrieve earthquake source parameters from the inverted source spectra. The obtained stress drops range from 0.02 to 16 MPa with a mean value of 1.1 MPa. Stress drop and radiated energy show fairly self-similar scaling with seismic moment over the available magnitude range; however, the magnitude range of this study is too narrow to draw a definite conclusion on source scaling characteristics. The obtained moment magnitude M w and the local magnitude M L are linearly correlated and approximately equivalent in the range of M w 3–4. For larger events, M w generally underestimates M L by about 0.1–0.5 magnitude units. The estimated site amplification functions for horizontal component (GIT H) are nearly flat with no obvious pre-dominant frequency peaks for most stations, as expected for the sites of permanent broad-band seismic stations located on rock, though a few stations show amplification peaks from 1 to 8 Hz, with a maximum amplification of about a factor of 7 with respect to the reference site. The evaluated site responses for the vertical components present remarkable amplification or deamplification, leading to differences of the H/V amplitude levels in comparison with the GIT H amplification curves. The results of this study provide a valuable basis for predicting appropriate ground motions in a context of seismic hazard assessment. [ABSTRACT FROM AUTHOR]

Comprised of S waves trapped in the Earth's crust, the high-frequency (2–10 Hz) Lg wave is important to discriminating earthquakes from explosions by comparing its amplitude and waveform to those of Pg and Pn waves. Lateral variations in crustal structure, including variations in crustal thickness, intrinsic attenuation and scattering, affect the efficiency of Lg propagation and its consistency as a source discriminant at regional (200–1500 km) distances. To investigate the effects of laterally varying Earth structure on the efficiency of propagation of Lg and Pg, we apply a radiative transport algorithm to model complete, high-frequency (2–4 Hz), regional coda envelopes. The algorithm propagates packets of energy with ray theory through large-scale 3-D structure and includes stochastic effects of multiple scattering by small-scale heterogeneities within the large-scale structure. Source-radiation patterns are described by moment tensors. Seismograms of explosion and earthquake sources are synthesized in canonical models to predict effects on waveforms of paths crossing regions of crustal thinning (pull-apart basins and ocean/continent transitions) and thickening (collisional mountain belts). For paths crossing crustal thinning regions, Lg is amplified at receivers within the thinned region but strongly disrupted and attenuated at receivers beyond the thinned region. For paths crossing regions of crustal thickening, Lg amplitude is attenuated at receivers within the thickened region, but experiences little or no reduction in amplitude at receivers beyond the thickened region. The length of the Lg propagation within a thickened region and the complexity of over- and underthrust crustal layers can produce localized zones of Lg amplification or attenuation. Regions of intense scattering within laterally homogeneous models of the crust increase Lg attenuation but do not disrupt its coda shape. [ABSTRACT FROM AUTHOR]

On 2013 April 13, an inland earthquake of Mw 5.8 occurred in Awaji Island, which forms the western boundary of the Osaka sedimentary basin in western Japan. The strong ground motion data were collected from more than 100 stations within the basin and it was found that in the Osaka Plain, the pseudo velocity response spectra at a period of around 6.5 s were significantly larger than at other stations of similar epicentral distance outside the basin. The ground motion lasted longer than 3 min in the Osaka Plain where its bedrock depth spatially varies from approximately 1 to 2 km. We modelled long-period (higher than 2 s) ground motions excited by this earthquake, using the finite difference method assuming a point source, to validate the present velocity structure model and to obtain better constraint of the attenuation factor of the sedimentary part of the basin. The effect of attenuation in the simulation was included in the form of Q(f) = Q0(f/f0), where Q0 at a reference frequency f0 was given by a function of the S-wave velocity, Q0 = αVS. We searched for appropriate Q0 values by changing α for a fixed value of f0 = 0.2 Hz. It was found that values of α from 0.2 to 0.5 fitted the observations reasonably well, but that the value of α = 0.3 performed best. Good agreement between the observed and simulated velocity waveforms was obtained for most stations within the Osaka Basin in terms of both amplitude and ground motion duration. However, underestimation of the pseudo velocity response spectra in the period range of 5-7 s was recognized in the central part of the Osaka Plain, which was caused by the inadequate modelling of later phases or wave packets in this period range observed approximately 2 min after the direct S-wave arrival.We analysed this observed later phase and concluded that it was a Love wave originating from the direction of the east coast of Awaji Island. [ABSTRACT FROM AUTHOR]