Search

The publication presents the results of the measurements of the operating parameters of a spark-ignition engine fueled with 95-octane unleaded gasoline (ES95) and ethyl alcohol, approx. 92%. The measurements were carried out at a constant load: an engine speed of 1500 rpm and a constant pressure in the intake system - MAP = 0.45 bar. For each type of fuel, the measurements were carried out in two series for two variables. The ignition crank angle was varied in the range of 0°÷40° and the mixture composition λ in the range of 0.85-1.25. The recorded engine performance parameters included torque, intake manifold pressure, intake air temperature, exhaust gas temperature and temporal fuel consumption; and exhaust gas composition was examined in terms of carbon monoxide, hydrocarbons and nitrogen oxides. The study showed that an ethanol-fueled engine has lower average efficiency compared to a gasoline one. The highest efficiency for ethanol was obtained for rich mixtures in the range λ = 0.85-1.0 and at high ignition advance angles. The use of alcohol fuel showed a very favorable effect on the composition of exhaust gas and a significantly lower content of harmful exhaust components was demonstrated. For the same operating points, carbon monoxide content was reduced by an average of 15%, and hydrocarbons and nitrogen oxides by an average of 80%. [ABSTRACT FROM AUTHOR]

This article presents an analysis of the influence of oil service life on the performance parameters of an aircraft piston engine lubrication system used in an ultralight aircraft. The ageing of oil between oil changes causes a change in its parameters (such as density, viscosity...). These parameters have a strong influence on the level of protection of the lubricated components. Currently, in aircraft, oil changes are carried out according to a time schedule - oil is changed every fixed period (residual life) regardless of its actual condition. The task of this article is to test the possibility of an indirect assessment of oil condition based on analysis of changes in selected parameters of engine lubrication system operation during normal operation. The oil warm-up speed during the pre-start procedure and the dependence of oil pressure on engine speed were assumed for the analysis. The study was conducted on an ultralight rotorcraft during normal operation. Selected first daily flights directly after oil change, and after 17, 32, 50 and 66 hours of operation were analysed. It was shown that the warm-up rate changes in the samples analyzed, but that this change may also be due to factors other than oil operating time. In the case of the oil pressure vs. speed characteristics, different characteristics were shown for different operating time, but no specific dependencies were found. [ABSTRACT FROM AUTHOR]

The article presents the results of statistical analysis of aircraft piston engine operational parameters during normal operating conditions. Test was carried out on ultralight gyroplane Tercel produced by Aviation Artur Trendak equipped with CA 912 ULT piston engine. Research was conducted under normal operating conditions of the autogyro and data was collected from 15 independent tests including a total of 14 flight hours conducted during training flights. Engine and flight parameters were recorded at 9 Hz during each flight using on-board Flight Data Recorded system. The data collected was subjected to statistical analysis to determine the statistical distribution of parameters defining the engine's operating condition. The analysis covered engine speed, intake manifold pressure, oil temperature, head temperature and exhaust gas temperature. The results were presented in the form of histograms showing the characteristic ranges of the parameters in aviation engine operation. An analysis of the rate of change of the analysed parameters was then carried out. This was the basis for defining the engine's steady state. The results showed that the steady state of the engine under these operating conditions accounted for more than 78% of the total engine operating time. A Power Consumption Ratio indicating the load range of the engine was determined for steady states. It was shown that most of the time the motor operates at an average load of between 50% and 80% of the nominal value. [ABSTRACT FROM AUTHOR]

The article presents the results of analysis of operational parameters of piston engine CA 912 ULT which is a propulsion system of ultralight gyroplane Tercel produced by Aviation Artur Trendak. Research was conducted under normal operating conditions of the autogyro and data was collected from 20 independent tests including a total of 28 flight hours, divided into training flights and competition flights. Engine speed, manifold air pressure and temperature, fuel pressure, injection time, and head temperature were recorded at 9 Hz during each flight. Collective results were presented to show the statistical analyses of the individual parameters by determining the mean values, standard deviations and histograms of the distribution of these parameters. Histograms of operating points defined by both engine speed and manifold air pressure were also determined. Analyses of the engine dynamics as a distribution of the rate of change of the engine rotational speed were also carried out. It was shown that the engine operating points are concentrated mainly in the range of idle and power above 50% of nominal power. The most frequent range is 70-80% of nominal power. It was also shown that the dynamics of engine work in real operating conditions is small. It was also shown that the way of use significantly influences the distribution of operating points. During training flights, an increase in the number of take-offs and landings causes an increase in the amount of engine work at take-off and nominal power and at idle. [ABSTRACT FROM AUTHOR]