Search

Comprehensive scanning transmission electron microscopy (STEM) analysis of Li4 Ti5 O12 (LTO) powder modified by deposited Ag nanoparticles was performed. Nanocomposite powders with Ag content of 1 wt.%, 4 wt.%, 10 wt.% were fabricated in a chemical process from suspensions of Ag and LTO. Apart from the STEM results, the presence of pure silver on the surface of the ceramic powder was confirmed by XRD and XPS analyses. The silver particles deposited on the LTO particles were characterized using the EDS mapping technique. The quantified results of the EDS mapping showed a relatively homogenous distribution of silver nanoparticles on the powder surface for every metal content. The mean diameter of the nanoparticles deposited on the LTO powder was about 4 nm in all cases. An increase in the Ag content during chemical surface modification did not cause changes in the microstructure. Focusing on an analysis of the metallic nanoparticles on the ceramic powder, electron tomography was used as an investigative technique. A very precise analysis of three-dimensional nanostructures is desirable for a comprehensive analysis of complex materials. The quantified analysis of the Ag nanoparticles visualized using electron tomography confirmed the results of the size measurements taken from the two-dimensional EDS maps., (© 2016 The Authors Journal of Microscopy © 2016 Royal Microscopical Society.)

In this study, microstructures of dental composites were observed using high resolution scanning transmission electron microscopy (HR STEM). Samples for these observations were prepared by focused ion beam system. Two kinds of dental composites were investigated: (1) polymer-ceramic composite containing nano-sized ceramic fillers and (2) ceramic-polymer composite based on the nano-structured yttrium stabilized zirconia. The first composite is a popular material for dental fillings whereas the second is used for the fabrication of fixed partial dentures. The results are discussed in terms of the evaluation of fabrication process of the composites.

Transmission electron microscopy studies of the artefacts in the form of network of dislocations induced by focused ion beam technique in austenitic stainless steel have been performed. Images of the microstructure with different diffraction vector g were analyzed. Transmission electron microscopy investigations of the artefacts induced by focused ion beam machining in the austenite revealed set of parallel dislocations with edge character located near the free surface of the thin foils.