Search

The development of paper-based flexible electronic devices can reduce the use of traditional petroleum-based polymer substrates, thereby reducing environmental pollution. However, paper substrates tend to absorb moisture, which would degrade the performance of electronic devices. Polytetrafluoroethylene (PTFE) films were proposed as coatings for the paper substrate to improve the hydrophobic performance of the paper, thereby enhancing the stability of paper-based device. Hydrophobic PTFE films were deposited on both sides of the paper substrate using electron beam evaporation, which block the paper substrate from absorbing moisture. The zinc oxide (ZnO) film was sputtered onto the paper substrate and fabricated into ultraviolet photodetectors (UVPD). Numerical simulations show that the introduction of PTFE films can greatly reduce the stress from 3.21 × 109 N m−2 to 3.50 × 107 N m−2 in the ZnO epitaxial layer on the paper substrate. The stability and detectivity of the UVPD with PTFE coatings are greatly improved compared to that without PTFE coatings, providing a promising avenue for fabricating stable, superior, and sustainable paper-based electronic devices. [ABSTRACT FROM AUTHOR]

Alkenyl succinic anhydride (ASA) is a reactive sizing agent that can impart good water repellence to paper by decreasing the wettability of the cellulose fibers. However, ASA can undergo hydrolysis, which is detrimental to the ASA sizing efficiency. In order to improve the ASA emulsion stability and ASA sizing efficiency, we used cationically modified cellulose nanocrystals (CNCs) to stabilize the cationic starch-emulsified ASA. Transmission electron microscope observation revealed that ASA droplets were well shielded by both the cationic CNCs and cationic starch, which may be responsible for the improved stabilization of ASA. The Hercules size test sizing degree, contact angle and particle size measurements demonstrated that cationic CNCs-ASA sized paper exhibited improved results in comparison with the control (without cationic CNCs under otherwise the same conditions). Furthermore, the resulting cationic CNCs-ASA system can improve the tensile index and burst index of the sized paper. [ABSTRACT FROM AUTHOR]