Search

Objective: To investigate the effect of Kangquan Recipe (康泉方, KQR) on bone morphogenetic protein and activin membrane-bound inhibitor (BAMBI) expression and its mechanism in rats with benign prostatic hyperplasia (BPH). Methods: Forty-eight male Sprague-Dawley rats were divided into 6 groups using a random number table, with 8 in each group: the normal group (normal saline 10 mL/kg), the model group (normal saline 10 mL/kg), the finasteride group (0.5 mg/kg), the low-dose KQR group (3.5 g/kg), the middle-dose KQR group (7 g/kg), and the high-dose KQR group (14 g/kg). The 40 rats were subcutaneously injected with testosterone propionate after castration for 30 days to establish the BPH rat model except for those in the normal group. At the same time, the corresponding drugs were administered by gavage for 30 consecutive days. The effects of different doses of KQR on the protate wet weight, prostate volume and prostate index (PI) were observed. The changes in histopathology were monitored with hematoxylin-eosin staining. BAMBI protein and mRNA expression contents were determined by Western blot and quantitative real-time polymerase chain reaction, respectively. Results: All doses of KQR could decrease prostatic epithelial tissue proliferation. Compared to the model group, the high and middle-dose KQR significantly reduced prostate wet weight, prostate volume and PI; increased BAMBI protein expression in the hypothalamus, pituitary and prostate tissue; all doses of KQR up-regulated BAMBI mRNA expression in serum, prostatic fluid and prostate tissue (P<0.05 or P<0.01). Conclusions: KQR could inhibit the proliferation of rat prostatic tissue, promote BAMBI protein expression in the hypothalamic-pituitary-prostate of rats with BPH; and increase BAMBI mRNA expression in the blood, prostatic fluid and prostate tissue of rats with BPH, showing a dose-effect relationship. KQR can be used as a potential drug for the treatment of BPH. [ABSTRACT FROM AUTHOR]

Mo-doped TiO2 [≤ 0.20 wt% Mo; ≤ 0.10 mol% (metal basis)] with conjugated polyvinyl alcohol (TiO2/C-PVA) composite thin films was prepared by sol-gel dip coating on polished fused SiO2 substrates, followed by annealing at 180 °C for 4 h. These conditions were sufficient for solid solubility, despite the unusually low annealing temperature. The annealed thin films consisted of homogeneously distributed individual and slightly agglomerated anatase grains in a continuous C-PVA matrix characterized by the carbon double bond formed upon conjugation. The films exhibited drying shrinkage cracks, which increased consistently in extent with increasing Mo-doping concentration, effectively increasing the number of exposed TiO2 particles. Mo addition enhanced anatase nucleation, recrystallization, and growth at lower doping concentrations (up to ≤ 0.10 wt%), thereby increasing crystallinity. However, increasing doping levels (> 0.10 wt%) appeared to exceed the solubility limit, resulting in supersaturation and significant lattice destabilization. Mo-doping also caused the Ti2p XPS peaks to shift to lower binding energies and the Mo3d peaks to shift to higher binding energies. These data are consistent with thermodynamically unstable Ti4+ → Ti3+ conversion and thermodynamically stable Mo5+ → Mo6+ conversion, which are interpreted in terms of intervalence charge transfer (IVCT), in which charge compensation is achieved through majority Ti4+ → Ti3+ reduction plus Mo5+ → Mo6+ oxidation. Ti3+ concentration also reflects a direct correlation with the Mo-doping concentration and resultant IVCT within the Mo solubility limit and a reverse effect upon supersaturation. There is a correlation with the Eg but this can be attributed to recrystallization rather than a semiconducting effect. No effect of midgap state formation from enhancement of the VO·· concentration is expected because IVCT is a redox effect only and dissolution of Mo5+ or Mo6+ would generate Ti vacancies. The methylene blue dye degradation data exhibited the same trend but at a significant level (90.6% degradation), thus indicating that the mechanism dominating the photocatalytic performance is the recrystallization of the anatase and/or the modification of the semiconducting properties induced by Mo-doping, as indicated by the trends in band gap. [ABSTRACT FROM AUTHOR]

Transparent TiO films (~50-540 nm thick) were spin-coated in multiple cycles by sol-gel on soda-lime-silica glass and annealed at 450 °C for 2 h. Analyses included mineralogy (XRD), optics (UV-Vis), chemistry (XPS), microstructure and topography (SEM, AFM), and hydrophilicity (sessile drop). The microstructures were discontinuous (1 cycle), continuous (4-11 cycles), and damaged (13-15 cycles), with the highest quality films being those fabricated using 7-11 cycles. The thickest films were damaged as a result of shrinkage during annealing, which may have occurred from a two-stage process of dehydroxylation followed by pyrolysis. The single-crystal grain sizes were ~27 nm for the films and the roughness increased with increasing thickness. The hydrophilicity showed clear correlations with the roughness and surprisingly, not with the Ti, -OH, and Na contents. The role of the glass also was critical to the absorption/transmission of radiation as well as the wetting. That is, the discontinuous and damaged films showed high wetting angles and the continuous films showed low wetting angles. Correlation was observed between the amounts of different contaminants from glass and the free energies of formation for TiO to TiO under the influence of these contaminants. This relation was attributed to the driving force for oxide bond formation, where the only slightly negative free energy of reaction with Na allowed its relatively free diffusion through the microstructure until it achieved saturation solubility, although all of the main glass components effectively achieved saturation solubility under the modest kinetics of equilibration that were used. [ABSTRACT FROM AUTHOR]