Search

An introduction is presented in which the editor discusses various reports within the issue on topics including seismic processing, magnetic data analysis and variations in geothermal gradient patterns on basis of reflection data from Taiwan.

During TAiwan Integrated GEodynamics Research of 2009, we investigated data from thirty-seven ocean-bottom seismometers (OBS) and three multi-channel seismic (MCS) profiles across the deformation front in the northernmost South China Sea (SCS) off SW Taiwan. Initial velocity-interface models were built from horizon velocity analysis and pre-stack depth migration of MCS data. Subsequently, we used refracted, head-wave and reflected arrivals from OBS data to forward model and then invert the velocity-interface structures layer-by-layer. Based on OBS velocity models west of the deformation front, possible Mesozoic sedimentary rocks, revealed by large variation of the lateral velocity (3.1-4.8 km/s) and the thickness (5.0-10.0 km), below the rift-onset unconformity and above the continental crust extended southward to the NW limit of the continent-ocean boundary (COB). The interpreted Mesozoic sedimentary rocks NW of the COB and the oceanic layer 2 SE of the COB imaged from OBS and gravity data were incorporated into the overriding wedge below the deformation front because the transitional crust subducted beneath the overriding wedge of the southern Taiwan. East of the deformation front, the thickness of the overriding wedge (1.7-5.0 km/s) from the sea floor to the décollement decreases toward the WSW direction from 20.0 km off SW Taiwan to 8.0 km at the deformation front. In particular, near a turn in the orientation of the deformation front, the crustal thickness (7.0-12.0 km) is abruptly thinner and the free-air (−20 to 10 mGal) and Bouguer (30-50 mGal) gravity anomalies are relatively low due to plate warping from an ongoing transition from subduction to collision. West of the deformation front, intra-crustal interfaces dipping landward were observed owing to subduction of the extended continent toward the deformation front. However, the intra-crustal interface near the turn in the orientation of the deformation front dipping seaward caused by the transition from subduction to collision. SE of the COB, the oceanic crust, with a crustal thickness of about 10.0-17.0 km, was thickened due to late magmatic underplating or partially serpentinized mantle after SCS seafloor spreading. The thick oceanic crust may have subducted beneath the overriding wedge observed from the low anomalies of the free-air (−50 to −20 mGal) and Bouguer (40-80 mGal) gravities across the deformation front. [ABSTRACT FROM AUTHOR]

We interpret seven two-dimensional deep-penetration and long-offset multi-channel seismic profiles in the northernmost South China Sea area, which were collected by R/V Marcus G. Langseth during the TAIwan GEodynamics Research (TAIGER) project in 2009. To constrain the crustal characteristics, magnetic inversion and forward magnetic modeling were also performed. The seismic results clearly show tilted faulting blocks in the upper crust and most of the fault plane connects downward to a quasi-horizontal detachment as its bottom in the south of the Luzon-Ryukyu transform plate boundary. North of the plate boundary, a small-scale failed rifted basin (minimum 5 km in crustal thickness) with negative magnetization probably indicates an extended continental origin. Significant lower crustal material (LCM) was imaged under a crustal fracture area which indicated a continent and ocean transition origin. The thickest LCM (up to 6.5 km) is located at magnetic isochron C15 that is probably caused by the magma supply composite of a Miocene syn-rift volcanic event and Pliocene Dongsha volcanic activity for submarine volcanoes and sills in the surrounding area. The LCM also caused Miocene crustal blocks to be uplifted reversely as 17 km crustal thickness especially in the area of magnetic isochron C15 and C16. In addition, the wide fault blocks and LCM co-existed on the magnetic striped area (i.e. C15-C17) in the south of the Luzon-Ryukyu transform plate boundary. Magnetic forward modeling suggests that the whole thick crustal thickness (>12 km thick) needs to be magnetized in striped way as oceanic crust. However, the result also shows that the misfit between observed and synthetic magnetic anomaly is about 40 nT, north of isochron C16. The interval velocity derived from pre-stack time migration suggests that the crust is composed of basaltic intrusive upper crust and lower crustal material. The crustal nature should refer to a transition between continent and ocean. Thus, the magnetic reversals may be produced in two possible ways: basaltic magma injected along the crustal weak zone across magnetic reversal epoch and because some undiscovered ancient piece of oceanic crust existed. The crustal structure discrimination still needs to be confirmed by future studies. [ABSTRACT FROM AUTHOR]

Horizon velocity analysis and pre-stack depth migration of seismic profiles collected by R/V Maurice Ewing in 1995 across the accretionary prism off SW Taiwan and along the continental slope of the northernmost South China Sea were implemented for identifying gas hydrates. Similarly, a survey of 32 ocean-bottom seismometers (OBS), with a spacing of about 500 m, was conducted for exploring gas hydrates on the accretionary prism off SW Taiwan in April 2006. Travel times of head wave, refraction, reflection and converted shear wave identified from the hydrophone, vertical and horizontal components of these OBS data were applied for imaging P-wave velocity and Poisson's ratio of hydrate-bearing sediments. In the accretionary prism off SW Taiwan, we found hydrate-bearing sediment, with a thickness of about 100-200 m, a relatively high P-wave velocity of 1.87-2.04 km/s and a relatively low Poisson's ratio of 0.445-0.455, below anticlinal ridges near imbricate emergent thrusts in the drainage system of the Penghu and Kaoping Canyons. Free-gas layer, with a thickness of about 30-120 m, a relatively low P-wave velocity of 1.4-1.8 km/s and a relatively high Poisson's ratio (0.47-0.48), was also observed below most of the bottom-simulating reflectors (BSR). Subsequently, based on rock physics of the three-phase effective medium, we evaluated the hydrate saturation of about 12-30% and the free-gas saturation of about 1-4%. The highest saturation (30% and 4%) of gas hydrates is found below anticlines due to N-S trending thrust-bounded folds and NE-SW thrusting and strike-slip ramps in the lower slope of the accretionary prism. We suggest that fluid may have migrated through the relay-fault array due to decollement folding and gas hydrates have been trapped in anticlines formed by the basement rises along the thrust faults. In contrast, in the rifted continental margin of the northernmost South China Sea, P-wave velocities of 1.9-2.2 km/s and 1.3-1.6 km/s, and thicknesses of about 50-200 m and 100-200 m, respectively, for a hydrate layer and a free-gas layer were imaged below the remnant and erosional ridges in the upper continental slope. High P-wave velocity of hydrate-bearing sediment below erosional ridges may also indicate high saturation of hydrates there. Normal faults due to rifting in the South China continental crust may have provided conduits for gas migration below the erosional ridges where P-wave velocity of hydrate-bearing sediment in the passive continental margin of the northernmost South China Sea is greater than that in the active accretionary prism off SW Taiwan. [ABSTRACT FROM AUTHOR]