Search

Stacks of superconducting REBCO tapes (or "stacks") can trap high magnetic fields, above 17 T. However, relatively low oscillating transverse magnetic fields can fully demagnetize the stacks. This is an issue if the stacks act as poles in the rotor of a superconducting motor, for instance. Here, we study the drastic suppression of cross-field demagnetization in stacks by soldering the tapes at the ends using a normal conductor. In particular, we analyzed by numerical modeling a stack of five REBCO thin films connected at the ends by resistances. The computed trapped field of a stack with zero solder resistance decays very fast at the beginning but then tends to stabilize to relatively high values, while the trapped field of an isolated stack (infinite resistance at the ends) decays further (it decays to zero if the transverse field is above the parallel penetration field). For intermediate solder resistances, the stable value of the trapped magnetic field is in between those of the isolated and zero-resistance configurations. Since the stable trapped field in soldered stacks increases with the number of tapes, stacks of sufficiently high number of soldered tapes could be immune to cross-field demagnetization. This opens the gate for a new kind of superconductors that mostly behave as bulks, especially if the stacks are made of delaminated tapes or it is possible to solder the tapes by very low resistance. [ABSTRACT FROM AUTHOR]

High temperature superconducting (HTS) dynamos are promising devices that can inject large DC currents into the winding of superconducting machines or magnets in a contactless way. Thanks to this, troublesome brushes in HTS machines or bulky currents leads with high thermal losses will be no longer required. The working mechanism of HTS dynamo has been controversial during the recent years and several explanations and models have been proposed to elucidate its performance. In this paper, we present the first three-dimensional (3D) model of an HTS flux pump, which has good agreement with experiments. This model can be beneficial to clarify the mechanism of the dynamo and pinpoint its unnoticed characteristics. Employing this model, we delved into the screening current and electric field distribution across the tape surface in several crucial time steps. This is important, since the overcritical screening current has been shown to be the reason for flux pumping. In addition, we analyzed the impact of both components of electric field and screening current on voltage generation, which was not possible in previous 2D models. We also explored the necessary distance of voltage taps at different airgaps for precise measurement of the voltage across the tape in the dynamo. [ABSTRACT FROM AUTHOR]

Superconducting stacks and bulks can act as very strong magnets (more than 17 T), but they lose their magnetization in the presence of alternating (or ripple) transverse magnetic fields, due to the dynamic magneto-resistance. This demagnetization is a major concern for applications requiring high run times, such as motors and generators, where ripple fields are of high amplitude and frequency. We have developed a numerical model based on dynamic magneto-resistance that is much faster than the conventional Power-Law-resistivity model, enabling us to simulate high number of cycles with the same accuracy. We simulate demagnetization behavior of superconducting stacks made of 10–100 tapes for up to 2 million cycles of applied ripple field. We found that for high number of cycles, the trapped field reaches non-zero stationary values for both superconducting bulks and stacks; as long as the ripple field amplitudes are below the parallel penetration field, being determined by the penetration field for a single tape in stacks. Bulks keep substantial stationary values for much higher ripple field amplitudes than the stacks, being relevant for high number of cycles. However, for low number of cycles, stacks lose much less magnetization as compared to bulks. [ABSTRACT FROM AUTHOR]