Search

This paper analyzed the strong motion characteristics based on 86 three-component strong motion records of the MW 6.6 Luding earthquake. Additionally, the factors that influence the variation in ground motion for three earthquakes with similar magnitude in Sichuan Province were investigated. The analysis result indicates a strong correlation between the observed ground motion parameters and the distribution of published Modified Mercalli Intensity. The residual analysis reveals that the spectral accelerations at periods 0.1–10.0 s are amplified to 0.0798–0.3057 times the mean level in the rupture forward direction and weakened to 0.0738–0.2831 times the mean level in the rupture backward direction. The maximum pulse direction recorded by the 51LDJ station is N6°E, aligning with the vertical fault direction. The velocity pulses has distinct bidirectional pulses in the waveforms, with a PGV of 37.0 cm/s. The source effect of the strike-slip MW 6.6 Luding and MW 6.5 Jiuzhaigou earthquakes on ground motion is relatively less significant compared to the average level of mainshocks in southwest China. However, the thrust-fault MW 6.7 Lushan earthquake exhibits a stronger source effect on ground motion during short and medium periods, but a weaker source effect during long periods when compared to the average level. The anelastic attenuation of the Longmenshan, Xianshuihe, and Huya fault zones in Sichuan exhibits significant regional variation and periodic correlation. This phenomenon is closely linked to the regional tectonic background variations and the heterogeneity of crustal structure within the area. [ABSTRACT FROM AUTHOR]

The feasibility of using a dense seismic array with an airgun source to study the quality factors of shallow media is verified. Data were obtained from 37 stations in the dense seismic array located in Binchuan, Yunnan Province, China, and the amplitude–distance attenuation method and the coda normalization method were applied to calculate the S-wave quality factors in the area. The amplitude–distance attenuation method yielded Q s - 1 =0.0260 ± 0.0103, and the frequency-dependent Q s - 1 calculated by the coda normalization method can be expressed by the power law Q s - 1 (f) ≅ 0.0554 f - 0.5643 . The consistency between the results of these two methods shows that a dense seismic array with an airgun source can be used to study the attenuation characteristics of shallow media. The amplitudes at some points deviate substantially from the fitted curve and thus have a certain influence on the fitting results; hence, we must select high-precision data for the calculation. Given the topography, we speculate that the anomalous stations located on the edge of the Binchuan Basin and in the western hilly area are due to the edge effect of the basin and the weak attenuation of the hilly area and that the anomalous station located in the northern Binchuan depocenter is attributable to local site factors. Compared with the Q s - 1 estimated by previous studies, the Q s - 1 in the Binchuan area is found to lie between those of the hard soil and sedimentary rock and is similar to the Q s - 1 in the North China Basin, corresponding to the shallow velocity structure in this area. [ABSTRACT FROM AUTHOR]

Current practice uses predictive models to extrapolate long-period response spectra based on far-field recordings in moderate and weak earthquakes. However, the spectra are not long enough and the data are often not reliable, which means that the seismic design code cannot accurately define seismic design requirements for long-period structures. The near-field recordings in the main-shock of the Chi-Chi earthquake have a large signal-to-noise ratio (SNR), which makes them suitable for studying the long-period acceleration response spectrum up to 20 sec. The acceleration response spectra from 246 stations within 120 km of the causative fault are statistically analyzed in this paper. The influence of distance and site conditions on long-period response spectrum is discussed, and the shapes of the amplification spectra are compared with the standard spectra specified in the seismic design code of China. Finally, suggestions for future revisions to the code are proposed. [ABSTRACT FROM AUTHOR]

39473 Pn travel times are inverted to tomographically image both lateral variation and anisotropy of uppermost mantle velocities beneath China continent. The result indicates that the overall average Pn velocity of uppermost mantle in the studied region is 8.0 km/s and the regional velocity fluctuation varies from ?0.30 km/s to +0.35 km/s. Pn velocities higher than 8.2 km/s are found in the regions surrounding Qingzang Plateau, such as Junggar Basin, Tarim Basin, Qaidam Basin and Sichun Basin. Pn velocities slightly lower than the average are found in western Sichuan and Yunnan, Shanxi Graben and Bohai Bay region. A Pn velocity as low as 7.8 km/s may exist in the region striding the boundary between Guangxi and Guangdong provinces. In general, Pn velocity in tectonically stable region like cratonic platform tends to be high, while that in tectonically active region tends to be low. The regions in compressive setting usually show higher Pn velocity, while extensional basins or grabens generally display lower one. Anisotropy of Pn velocity is seen in some regions. In the southeastern region of Qingzang Plateau the directions of fastest Pn velocity show a rotation pattern, which may be related to southeastward escape of the plateau material due to the collision and compression of Indian Plate to Asia along Himalaya arc. Notable anisotropy also exists around Bohai Bay region, likely indicating crustal extending and possible magma activity therein. [ABSTRACT FROM AUTHOR]

In this study, the strong ground motion of the Jiuzhaigou Ms7.0 earthquake, which occurred in northern Sichuan, China, was simulated based on the stochastic finite-fault method. The earthquake event was recorded by 66 strong ground-motion stations operated by the China Strong Motion Networks Center. We simulated 11 records selected within 200 km source-to-site distance. According to previous studies and empirical relationships, we estimated the region-specific input parameters. The zero-distance kappa filter obtained had a value of 0.0206 s. Two different source models were applied in this study: the random slip model and specified slip model. Using the stochastic finite-fault method, we simulated the PGA, Fourier spectrum and response spectrum at all stations. The stochastic simulated result based on the specified slip distribution models had no significant bias at most stations. Using a model with a random slip distribution, the simulated response spectra also matched the observed result, which indicated that the stochastic finite-fault method is not very sensitive to the input slip distributions and fault dimensions. We divided the study area into 1116 sites to simulate the spatial distribution of PGA based on the two models. The simulated maximum intensity of the epicentral area reached level IX, which was similar to the observed maximum intensity and indicated that the simulated result could be used in prediction of an imminent earthquake disaster. For future earthquake prediction, seismic hazards could even be estimated quickly without obtaining detailed information about the fault plane. [ABSTRACT FROM AUTHOR]