Search

The aim of this study was to determine the changes occurring in the wood cellulose of the fast-growing poplar (Populus deltoides × maximowiczii) under the influence of steam explosion (SE) pretreatment. Cellulose from native wood and after pretreatment at 160 and 205 °C was isolated. Cellulose polymerization degree by size exclusion chromatography (SEC) and cellulose crystallinity index by Fourier transform infrared spectroscopy-attenuated total reflectance (FTIR-ATR) were determined. The profiles of sugars in the native wood and in the solid fraction after pretreatment (using the acid hydrolysis method) were also determined. In addition, the profile of monosaccharides in the liquid fraction obtained after steam explosion and in the liquid fraction after acid hydrolysis of the oligosaccharides were investigated using high-performance liquid chromatography (HPLC). This allowed to determine the change in the yield of hexoses and pentoses in the studied material. The behavior of cellulose in wood subjected to steam explosion at 160 and 205 °C and isolated by the Kürschner–Hoffer method was studied by determining the absorption bands of FTIR-ATR spectra. The lateral order index (LOI) of cellulose was calculated from the ratio of the intensity of the corresponding absorption bands A1422/A896 cm−1. Total crystallinity index (TCI) of cellulose was calculated from the ratio of the intensity of absorption bands A1372/A2900 cm−1. TCI of Kürschner-Hoffer cellulose isolated from wood subjected to steam explosion at 160 and 205 °C decreased by 5.6 and 5.0%, respectively, with regard to the applied temperature. LOI increased in cellulose isolated from wood subjected to steam explosion at 160 °C (by 0.7%) and at 205 °C (by 19.2%) in relation to the index of cellulose isolated from native wood. Kürschner–Hoffer cellulose isolated from wood subjected to steam explosion at 160 and 205 °C exhibited, respectively, a reduced degree of polymerization of about 11% and about 8%. Polydispersity index in Kürschner–Hoffer cellulose was 1% lower after both pretreatments than native sample. [ABSTRACT FROM AUTHOR]

In this paper, the influence of physicochemical pretreatment methods on the chemical composition, enzymatic hydrolysis efficiency and porosity of fast-growing Populus trichocarpa wood was compared. Among the pretreatment methods, the liquid hot water (LHW) and steam explosion (SE) were used, which were performed at three different temperatures (160 °C, 175 °C and 190 °C) and two residence times (15 min and 1 h). The chemical composition, enzymatic hydrolysis and porosity analysis were done for native wood and solid fraction obtained after LHW and SE pretreatments. The porosity analysis was performed by inverse size exclusion chromatography method. Additionally, inhibitors of hydrolysis and fermentation processes in the liquid and solid fractions obtained after pretreatments were examined. Based on the results, it was found that the tested pretreatments caused the greatest changes in the chemical content of hemicelluloses. It was found that after LHW and SE pretreatments up to 99.1% or 94.0%, respectively, of hemicelluloses were removed from the obtained solid fraction. Moreover, the LHW and SE processes greatly enhanced the enzymatic digestibility of fast-growing poplar wood. The highest glucose yield was achieved after 15 min of SE pretreatment at 190 °C and was 676.4 mg/g pretreated biomass, while in the case of xylose the highest value (119.3 mg/g pretreated biomass) was obtained after 15 min of LHW pretreatment at 160 °C. Generally, after SE pretreatment process, more inhibitors were formed, and a greater effect of porous structure development was noticed than after LHW pretreatment. Despite this difference, the average glucose contents and yields after enzymatic hydrolysis of pretreated biomass were generally similar regardless of the pretreatment used. [ABSTRACT FROM AUTHOR]

A study of the alkylation of 3% ReO/60%AlO-40%SiO catalyst using tetraethyllead (EtPb)(TEL) shows that the reaction time and temperature affect the catalyst activity and selectivity in the methyl erucate metathesis reaction. [ABSTRACT FROM AUTHOR]

6-nitrohexene-1 (6-NH-1) undergoes metathesis in the presence of 16 wt.% ReO/AlO/RM and 3 wt.% ReO/AlO-SiO/RM (where R = methyl, ethyl; M = Sn or Pb) catalysts. The system containing alumina as a support is more active. Tetramethyltin (TMT) and tetraethyllead (TEL) used as co-catalysts, exhibited similar activating effect which was greater than with tetraethyltin (TET). The best results were obtained when the Re:Sn(Pb) and 6-NH-1:Re ratios were equal, respectively, to 1:1 and 10:1. The alumina-silica supported catalysts activity can be enhanced by doping the support with very small amounts of molybdenum ions. [ABSTRACT FROM AUTHOR]