Search

A back-contact perovskite solar cell (BC-PSC) has been simulated. The J–V curves were calculated with different degrees of the interfacial recombination, and the characteristics of basic physical phenomena inside the device, including carrier concentration distribution, ion concentration distribution, electric potential change, and carrier recombination rate, have also been investigated. It was found that the effect of the perovskite layer's upper surface (US) interfacial recombination on the hysteresis phenomenon is greater than that of the perovskite layer's lower surface (LS) interfacial recombination. In addition, it has been found that the inverted hysteresis phenomenon occurs in the BC-PSC with the LS interfacial recombination. Moreover, the hysteresis loops corresponding to the US interfacial recombination of the perovskite layer were close to the short-circuit current side, and the hysteresis loops corresponding to the LS interfacial recombination of the perovskite layer were close to the open-circuit voltage side. These results indicate that both of the US and LS interface recombinations in the BC-PSC play a crucial role in the hysteresis phenomenon. [ABSTRACT FROM AUTHOR]

ZnTe/ZnTe:Cu complex layers deposited by vacuum co-evaporation have been introduced to CdS/CdTe solar cells. The C-V and I-V curves have been investigated and the effects of un-doped ZnTe layer thickness as well as annealing temperatures on I-V characteristics of CdTe solar cells have been studied. The results show that the “roll over” and “cross over” phenomena of dark and light I-V curves can be eliminated by use of ZnTe/ZnTe:Cu layer and the fill factor for a typical sample has increased to 73%, where there is no high resistance transparent layer. The reasons have been discussed combined with the energy band diagram of CdTe solar cells. [ABSTRACT FROM AUTHOR]