Search

Neutron imaging is used for direct observation of evolving water–air and deuterated water–normal water exchanges in flow experiments performed on a laboratory-deformed, microporous laminated limestone, an extremely fine-textured rock altered by arrays of superposed fractures generated in a rock mechanics apparatus. The neutron images document significant, evolving, water speed and flow direction variability at the deci-micron scale and spatially complex patterns of both increasing and decreasing water saturation. We infer that capillarity-driven and pressure-driven water movement occurs concurrently, in close proximity and in competition, and that as local and global water saturations evolve these two drivers can change their dominance in both matrix and deformed elements. Thin sections are used to obtain sub-micron resolution SEM images that provide multi-scale information on the textural features’ spatial arrangements. The textural characteristics are consistent with the inferences made from the coarser flow imaging. Alternating lamina types provide the primary lithological heterogeneity, while the experimentally created deformations lead to quasi-planar zones of highly comminuted matrix and fracture-like voids, each with lengths ranging from sub-mm to cm. Together deformation features delineate a partially connected array. The interplay between fluid movement through deformation features, and flow into (and out of) the laminae, implies near-equivalence of local driving pressure- and capillary-related energies, with subtle shifts in this balance as water saturation increases. The insights gained invite a re-examination of common rules-of-thumb for multi-phase fluid flow often adopted in fractured, low-permeability microporous rocks.

The most commonly used screens for neutron imaging consist of 6LiF + ZnS. This type of screen yields the highest light output per detected neutron. For high resolution, gadolinium oxysulfide (GOS, Gadox) screens are employed, which have a much higher detection efficiency, but a light output so much lower than LiF + ZnS that measurements are often limited by photon statistics. Historically, screens using boron as a neutron-sensitive material have not been very successful. However, a new preparation method was introduced recently that produces light output higher than Gadox with detection efficiency greater than LiF + ZnS. Measurements of these new borated screens were performed at the NeXT facility at ILL, Grenoble, in comparison to a high resolution Gadox screen.

The electrochemical reduction of CO2 is a pivotal technology for the defossilization of the chemical industry. Although pilot-scale electrolyzers exist, water management and salt precipitation remain a major hurdle to long-term operation. In this work, we present high-resolution neutron imaging (6 μm) of a zero-gap CO2 electrolyzer to uncover water distribution and salt precipitation under application-relevant operating conditions (200 mA cm−2 at a cell voltage of 2.8 V with a Faraday efficiency for CO of 99%). Precipitated salts penetrating the cathode gas diffusion layer can be observed, which are believed to block the CO2 gas transport and are therefore the major cause for the commonly observed decay in Faraday efficiency. Neutron imaging further shows higher salt accumulation under the cathode channel of the flow field compared to the land.

This communication explores the influence of boundary effects, embedded sensors and crack opening on high-temperature experiments of concrete as revealed by in situ neutron tomography. The hypotheses routinely taken about these experimental aspects in common practice are hereby reassessed in light of the insight given by noninvasive full-field measurements. Notably, we directly assess the heat and moisture insulation techniques and reveal the influence of temperature and gas pressure monitoring on the testing conditions, opening new perspectives toward their improvement.

The temporally and spatially resolved tracking of lithium intercalation and electrode degradation processes are crucial for detecting and understanding performance losses during the operation of lithium-batteries. Here, high-throughput X-ray computed tomography has enabled the identification of mechanical degradation processes in a commercial Li/MnO2 primary battery and the indirect tracking of lithium diffusion; furthermore, complementary neutron computed tomography has identified the direct lithium diffusion process and the electrode wetting by the electrolyte. Virtual electrode unrolling techniques provide a deeper view inside the electrode layers and are used to detect minor fluctuations which are difficult to observe using conventional three dimensional rendering tools. Moreover, the ‘unrolling’ provides a platform for correlating multi-modal image data which is expected to find wider application in battery science and engineering to study diverse effects e.g. electrode degradation or lithium diffusion blocking during battery cycling., The combination of X-ray and neutron CT enables 4D studies, i.e. to explore the evolution of 3D structures with time. Here the authors apply this approach to a Li-ion primary cell, revealing elsewhere unseen trends in the spatial distribution of performance aided by a new ‘unrolling’ methodology.