Search

Copper-coated graphite particles can be mass-produced by the cementation process using simple equipment. Graphite particulates that were coated with electroless copper and 5 wt.% SiC particulates were introduced into an aluminum alloy by compocasting to make A359 Al/5 wt.% SiC(p) composite that contained 2, 4, 6, and 8 wt.% graphite particulate composite. The effects of SiC particles, quantity of graphite particles, normal loading, sliding speed and wear debris on the coefficient of friction, and the wear rate were investigated. The results thus obtained indicate that the wear properties were improved by adding small amounts of SiC and graphite particles into the A359 Al alloy. The coefficient of friction of the A359 Al/5 wt.% SiC(p) composite that contained 6.0 wt.% graphite particulates was reduced to 0.246 and the amount of graphite film that was released on the worn surface increased with the graphite particulate content. The coefficient of friction and the wear rate were insensitive to the variation in the sliding speed and normal loading.

Colletotrichum acutatum causes anthracnose on peppers (Capsicum spp.), resulting in severe yield losses in Taiwan. Fungal isolates Coll-153, Coll-365 and Coll-524 collected from diseased peppers were found to differ in pathogenicity. Pathogenicity assays on various index plants revealed that Coll-524 was highly virulent and Coll-153 was moderately virulent to three commercially available pepper cultivars. Both isolates induced anthracnose lesions and produced abundant conidia. Coll-365 was only weakly virulent on pepper fruit, where it caused small lesions and hardly produced conidia on pepper fruit. However, Coll-365 was highly pathogenic to tomato fruit and mango leaves, where it caused anthracnose lesions and formed acervuli and conidia. All three isolates showed similar abilities in the attachment and germination of conidia, formation of highly branched hyphae and appressoria, penetration of cuticles, and infection of epidermal cells on chili peppers. Coll-365 accumulated less turgor pressure in appressoria but produced higher levels of cutinase and protease activity than Coll-153 and Coll-524 did. All three isolates invaded the neighbouring cells through plasmodesmata in chili peppers and showed similar pectinase or cellulase activities in culture. However, the most virulent strain Coll-524 expressed stronger laccase activity and was more resistant to capsaicin compared to Coll-153 and Coll-365. The three isolates are different in numbers and sizes of double-stranded RNAs. Depending on the cultivar genotypes, cellular resistance of chili pepper to C. acutatum might rely on the ability to restrict penetration, colonization, or conidiation of the pathogen. We conclude that the differences in pathogenicity among the three C. acutatum isolates of pepper are attributed to their ability to colonize the host plant.

The use of peripheral tramadol to block pain has been advocated. However, since its actions in the periphery have not been elucidated fully, we tested the hypothesis that peripheral tramadol blocks peripheral glutamate-induced nociceptive behaviour in mice.First, we compared the duration of paw licking after intraplantar (ipl.) glutamate administration, with and without tramadol, using a randomized blinded controlled design. Next, we established the half maximal effective concentrations (EC(50s)) for local tramadol and reference compound lidocaine in the hot water tail-flick latency test and the glutamate-induced paw allodynia assay.Tramadol reduced glutamate-induced paw licking from 33 +/- 12 sec to 4 +/- 4 sec (mean +/- SD; t test, P0.05; n = 6 per group). The tramadol and lidocaine EC(50) nerve conduction blocks in the tail did not differ significantly (84 +/- 24 mM vs 69 +/- 5 mM, respectively). Although tramadol reduced glutamate-induced allodynia (EC(50), 46 +/- 13 mM), lidocaine was more potent (EC(50), 13 +/- 5 mM; Dixon's up-and-down method; P0.05). Tramadol was 2.5 times as effective at blocking nerve conduction in the tail compared with allodynia in the paw.Local tramadol administration blocked nociceptive behaviour in mice induced by peripheral glutamate. Compared with lidocaine, the relative potency of tramadol was lower for blocking glutamate-induced allodynia than for sensory nerve conduction blockade, suggesting the activation of a pronociceptive receptor system in the periphery.

This study investigates the reliability of flip chip ball grid array (FCBGA) components with three types of solder materials: eutectic solder with a composition Sn63Pb37 and the lead-free solders SnAg3.0Cu0.5 and SnAg4.0Cu0.5. Two substrate-side solder mask (S/M) opening sizes, 0.4 mm and 0.525 mm, were used. Both the monotonic and cyclic mechanical four-point bend tests are conducted for the reliability assessment. It is found that the FCBGA components with SnAg3.0Cu0.5 solder have the best durability during the cyclic bend test, yet the eutectic solder is the strongest during the monotonic bend test. Besides, the FCBGA components with 0.525-mm S/M opening have around 3 times more life cycles than those with the 0.4-mm S/M opening in the cyclic bend test. It is also noteworthy that the lead-free solder materials have much variation in the failed cycles during the cyclic test. Moreover, the failure locations for those components with 0.4-mm S/M openings are found to be at the interface between the package side metal pad and the solder ball, and those with an S/M opening of 0.525 mm are observed to be failed mostly at the interface between the printed circuit board (PCB) side metal pad and the solder ball.

The main mechanisms for the hardening of metal materials are the multiplication, accumulation and interaction of dislocations. The dislocation density tensor can be decomposed into two parts: one is the plastic strain curl tensor and the other is the plastic curvature tensor. The influence of the plastic curvature can be characterized by the interaction between the Cauchy's stresses and the couple stresses. The plastic strain curl is supposed to play the most important role for the stress level. Three rotational degrees of freedom omega(i), named as micro rotation, are introduced besides the displacement components u(i). Micro rotations omega(i) have no direct dependence upon ui while the material rotation theta = Delta x u/2. The generalized normality law is used to describe constitutive relations of Cauchy's stresses versus strains and couple stresses versus curvatures. Plastic strain curl is incorporated into the instantaneous tangent modulus. In this way, the generalized equivalent stress is no longer a single-variable function of the generalized equivalent strain. The plastic strain energy density is no longer determined by the generalized equivalent strain solely, too. Based on the present theory, an FEM program is developed to simulate the microindentation tests on Copper and Tungsten. The calculated hardness is observed to elevate as the indent depth decreases. The calculated results agree well with the experimental data. The crack tip field for small scale yielding condition is also studied. The calculated results clearly show that the stress level near the crack tip with plastic strain curl effects is considerably higher than that in the conventional plasticity theory. The singularity of the mean stress near the crack tip is nearly equal to the square-root singularity, and the singularity of the effective stress field is slightly greater than the square-root singularity. Consequently, the singularity of stress components is also slightly greater than the square-root singularity. The J-integral is observed to be essentially path independent.

We recently proposed a strain gradient theory to account for the size dependence of plastic deformation at micron and submicron length scales. The strain gradient theory includes the effects of both rotation gradient and stretch gradient such that the rotation gradient influences the material character through the interaction between the Cauchy stresses and the couple stresses; the stretch gradient measures explicitly enter the constitutive relations through the instantaneous tangent modulus. Indentation tests at scales on the order of one micron have shown that measured hardness increases significantly with decreasing indent size. In the present paper, the strain gradient theory is used to model materials undergoing small-scale indentations. A strong effect of including strain gradients in the constitutive description is found with hardness increasing by a factor of two or more over the relevant range behavior. Comparisons with the experimental data for polycrystalline copper and single crystal copper indeed show an approximately linear dependence of the square of the hardness, H 2, on the inverse of the indentation depth, 1/h, I.e., H-2 proportional to 1/h, which provides an important self-consistent check of the strain gradient theory proposed by the authors earlier.

Many experimental observations have shown the influences of particle size on the mechanical properties of the particle-reinforced metal-matrix composite. However. the conventional theory cannot explain the phenomena because no length scale parameters are included in the conventional theory. In the present paper, the strain gradient theory proposed by Chen and Wang [32] is used, and a systematic research of the particle size effect in the particle-reinforced metal-matrix composite is carried out. Many composite factors, such as the particle size, the particle aspect ratio, the Young's modulus ratio of the particle to the matrix material, particle volume fraction and the strain hardening exponent of the matrix material, are investigated in detail. Two kinds of particle shapes, spheroidal particle and cylindrical particle, are considered to check the strength dependence of the particle shapes. Calculation to the special materials used by Ling [9] has been done, and the calculation results are consistent with the experimental results in Ling [9]. The material length scale parameter is predicted.

Inheritance of black leaf mold (BLM) (caused by Pseudocercospora fuligena) resistance was studied in four crosses involving two resistant Lycopersicon accessions (PI134417, L. hirsutum and PI254655, L. esculentum) and four susceptible Asian Vegetable Research and Development Center tomato lines (CLN657BC1F2-267-0-3-12-7, CL143-0-10-3-0-1-10, CLN698BC1F2-358-4-13 and CL5915-93D4-1-0-3). For each cross, six generations, i.e. P1, P2, F1, F2, BC1F1 and BC1F2 were evaluated following inoculations with isolate Pf-2 of P. fuligena. Chi-square analyses of the data based on the ratio of resistant to susceptible plants in the F2 in three of four crosses gave a good fit to a segregation ratio of 1 R : 15 S, and BC1F2 data in three of four crosses gave an acceptable fit to the segregation ratio of 1 R : 63 S. The results indicate that resistance to BLM may be conditioned by two recessive genes acting epistatically in both PI134417 and PI254655.

This project was designed to: (1) document the distribution and migration of organochlorine pesticide residues within marsh substrates of 18 St. Lucie County mosquito control impoundments located along the Indian River Lagoon estuary, and (2) evaluate the impact of water management techniques on residue mobility. Our results indicate that detectible concentrations of organochlorine compounds, applied between the late 1940s and early 1950s, are present in 16 of the 18 St. Lucie County mosquito control impoundments. These compounds are primarily restricted to the surficial, organic-rich wetland sediment, which, based upon geotechnical analysis, was exposed to the atmosphere at a time when the impoundments were subjected to pesticide treatment. Contaminated sediments are present below the surficial, organic-rich layer, suggesting that some vertical migration of pesticides has occurred. It is unlikely that leaching associated with the downward percolation of impounded water was responsible for this migration as pesticide residues were never detected within thein situ pore waters. An alternative explanation is that biological processes (e.g., rooting, burrowing) facilitated the downward flux of organochlorine compounds into sediment horizons not subjected to direct treatment. Eighty-eight surface water samples obtained from two impoundments subjected to contrasting water management techniques were analyzed for pesticide content. None of the surficial water samples collected in association with these impoundments contained detectible concentrations of organochlorine compounds. These samples were unfiltered and contained as much as 25 mg/1 of particulate organic matter. This suggests that the currently preferred management technique (RIM), which is designed to maintain water quality, limit mosquito production, and provide for ecological continuity, does not hydraulically mobilize pesticide residues into the Indian River Lagoon estuary.

Over 540 accessions of wild Lycopersicon species or their crosses with L. esculentum were screened for resistance in a series of trials. Forty-six accessions were selected for the final screening trial based on lower disease ratings in previous trials. Of these, L. hirsutum had the greatest number of resistant accessions, followed by L. esculentum and L. peruvianum. Twenty accessions were quantified for their levels of resistance based on leaf area infected, area under disease progress curve (AUDPC), and the degree of sporulation. There was a significant positive correlation between the AUDPC calculated from 20 accessions evaluated under growth room and field conditions. Five L. hirsutum accessions had no sporulation associated with leaf lesions, whereas L. esculentum accessions had an average of 1.6×104 conidia/cm2 of leaf tissue. There was significant positive correlation between the AUDPC values and the number of conidia per cm2 of leaf tissue.

Arsenic is a well-established carcinogen in humans, but there is little evidence for its carcinogenicity in animals and it is inactive as an initiator or tumor promoter in two-stage models of carcinogenicity in mice. Studies with cells in culture have provided some possible mechanisms by which arsenic and arsenical compounds may exert a carcinogenic activity. Sodium arsenite and sodium arsenate were observed to induce morphological transformation of Syrian hamster embryo cells in a dose-dependent manner. The trivalent sodium arsenite was greater than tenfold more potent than the pentavalent sodium arsenate. The compounds also exhibited toxicity; however, transformation was observed at nontoxic as well as toxic doses. At low doses, enhanced colony forming efficiency of the cells was observed. To understand the mechanism of arsenic-induced transformation, the genetic effects of the two arsenicals were examined over the same doses that induced transformation. No arsenic-induced gene mutations were detected at two genetic loci. However, cell transformation and cytogenetic effects, including endoreduplication, chromosome aberrations, and sister chromatid exchanges, were induced by the arsenicals with similar dose responses. These results support a possible role for chromosomal changes in arsenic-induced transformation. The two arsenic salts also induced another form of mutation-gene amplification. Both sodium arsenite and sodium arsenate induced a high frequency of methotrexate-resistant 3T6 cells, which were shown to have amplified copies of the dihydrofolate reductase gene.(ABSTRACT TRUNCATED AT 250 WORDS)

A new method, called Z-module reasoning, was formulated for proving and discovering theorems from ring theory. In a case study, the ZMR system designed to implement this method was used to prove the benchmark x3 ring theorem from associative ring theory. The system proved the theorem quite efficiently. The system was then used to prove the x4 ring theorem from associative ring theory. Again, a proof was produced easily. These proofs, together with the successes in proving other difficult theorems from ring theory suggest that the Z-module reasoning method is useful for solving a class of problems relying on equality reasoning. This paper illustrates the Z-module reasoning method, and analyzes the computer proof of the x3 ring theorem.

This paper presents our experiments using an automated reasoning program, called the Z-module reasoning system, to prove a number of interesting theorems in right alternative rings. Important results include a computer solution of the conjecture that (x, x, y)2 x(x, x, y) 2=0 holds in every right alternative ring and a computer solution of a generalized version of this conjecture. The paper illustrates how one uses the Z-module reasoning system to solve different problems with varying complexity.