Search

The purpose of this research was to investigate the effect of the shape of sodium salicylate (SS) particles on the physical properties as well as the in vitro aerosol performance of the granules granulated by the pressure swing granulation method. SS was pulverized with a jet mill (JM) to prepare the distorted particles, and SS aqueous solution was spray dried (SD) to prepare the nearly spherical particles. The particle size distribution, crushing strength, and pore size distribution of the granules were measured. The adhesive force of the primary particles in the granules was calculated according to Rumpf's equation. The in vitro aerosol performance of the granules was evaluated using a cascade impactor. Both JM and SD particles can be spherically granulated by the pressure swing granulation method without the use of a binder. The size of SD granules was smaller than that of JM granules. Although the crushing strength of the JM and SD granules is almost the same, the internal structures of JM granules and SD granules were found to differ, and the SD particles appear to have been condensed uniformly, resulting in a nearly spherical shape. In the inhalation investigation, the percentage of SS particles of appropriate size delivered to the region for treatment was noticeably higher for SD granules than for JM granules. This finding might be because the adhesive force of the SD primary particles was smaller than that of the JM primary particles in the granules and because the SD granules could be easily separated by air current to obtain the primary particles.

This investigation examined the application of acid-treated yeast cell wall (AYC) as a binder functioning as a disintegrant. Acetylsalicylic acid (ASA) was granulated with AYC, hydroxypropylcellulose (HPC), polyvinylpyrrolidone (PVP), or pullulan (PUL) and compressed into a tablet in the absence of disintegrant. Particle size and angle of repose of the granules, tensile strength, disintegration time, and water absorption behavior of the tablets and ASA release profiles from the tablets were measured. The surface of AYC-granules was observed with a scanning electron microscope. As was the case with the granules of HPC, PVP, or PUL, D50 of the granules of AYC increased with increasing AYC addition percentage, indicating that it is possible to granulate ASA with AYC. Tablets incorporating HPC, PVP, and PUL failed to disintegrate within 30 minutes at all percentages of binder addition because in the case of the HPC, PVP, or PUL tablets in the dissolution medium, water scarcely penetrated into the inner region of the tablet, causing no disintegration. In the case of the AYC tablets, disintegration was not detected at 3% or less of AYC. When AYC was equal to or greater than 5%, AYC tablets disintegrated in approximately 4 minutes and rapid ASA release from the tablets was observed. These results may have been caused by the following. In the case of the AYC 3% granules, ungranulated aspirin powder remained, but in the case of the AYC 5% granules, ASA powder was granulated and covered with AYC. Water absorption was observed initially; however, a plateau was reached in the case of the AYC 3%-tablet. In contrast, in the cases of the AYC 5% and more tablets, water absorption was greater and increased with time. The angle of repose of the AYC 5% granules was 25.7 degrees, which represented high fluidity. The tablets produced by compressing the granules demonstrated sufficient tensile strength greater than 0.8 MPa. The tablets rapidly disintegrated and rapid ASA release was obtained. AYC functioned as a binder at granulation; additionally, AYC served as a disintegrant in the dissolution of drug from the tablets. These results indicate that AYC affords high utility as a unique pharmaceutical additive possessing contrary functions such as binding and disintegration.