Search

The separation of Am(III) and Cm(III) by countercurrent chromatography (CCC) was achieved using the liquid phase systems "diamide–hydrogenated tetrapropylene (TPH)–HNO3" following the optimisation of: (i) the compositions of the mobile (HNO3 concentration) and the stationary (nature of the diamide and its concentration in TPH) phases, (ii) column length and (iii) operating parameters of the CCC (flow rate of the mobile phase and rotation speed of the coil column). The following diamide extractants have been studied: (i) N,N´-dimethyl-N,N´-dibutyltetradecylmalonamide (DMDBTDMA), (ii) N,N´-dimethyl-N,N´-dioctylhexyl-ethoxymalonamide (DMDOHEMA) and (iii) N,N´-dimethyl-N,N´-dibutyldodecylethoxymalonamide (DMDBDDEMA). It is shown that these diamides can be used for the separation of Am(III) and Cm(III) by CCC. Increasing the column length leads to an increase of the stationary phase retention on the column while improving the Am/Cm separation. Increasing the speed of rotation of the centrifuge from 660 to 950 rpm also results in increasing the stationary phase retention but does not influence the resolution of the Am/Cm separation. Decreasing the flow rate of the mobile phase from 1.0 to 0.5 mL/min leads to a better resolution of Am and Cm separation. The best Am/Cm separation was achieved with systems based on DMDBDDEMA and DMDOHEMA in TPH using a two-layer coil column and an isocratic elution mode. The application of CCC makes it possible to separate the elements within 100 min: the Cm fraction contains 99.5% of Cm(III) and 0.6% of Am(III) inventories and the Am fraction contains 99.4% of Am(III) and 0.5% of Cm(III).

Environmentally significant phosphorus species in water and phosphorus fractions in sediments are briefly discussed and the methods for their determination are described. One of the most critical analytical steps is the separation of the different forms which, after conversion into orthophosphates, may be determined by a multitude of various techniques. Spectrophotometric methods are often preferred for routine analysis. Several rapid automatic methods for the separation and determination of orthophosphate, linear polyphosphates, cyclic condensed phosphates and lower oxidation state anions of phosphorus, which may exist in natural and waste waters, have been developed. They are mainly based on the use of flow-injection analysis, high-performance liquid chromatography including ion chromatography, capillary electrophoresis and a few of other techniques. These methods have been described and critically evaluated.