Search

International audience; The study of complex reactive flows met in aeronautical engines is an experimental challenge that requires the development of noninvasive and precise measurement techniques. Coherent anti-Stokes Raman scattering (CARS) is a standard spectroscopic technique used for temperature measurements, which provides unmatched reliability and accuracy at high repetition rate thanks to its recent adaptation to femtosecond temporal regime. This paper reports the first demonstration of hybrid fs/ps-CARS thermometry in a representative aeronautical combustor (ONERA MICADO test bench, Reynolds number ≈105). Single-shot N2 CARS spectra have been recorded at 1 kHz, allowing temperature follow up, statistical and frequency (0.1–500 Hz) analysis of CH4/air flame at 0.34-MPa total pressure. The achieved results demonstrate the ability of the technique to be applied in representative engines conditions and its maturity for semi-industrial applications.

This paper demonstrates a new arrangement for wide-field CARS imaging. The setup using nanosecond dye lasers in a non-phase-matching illumination is presented. The chemical selectivity of the signal is demonstrated on polystyrene beads. Moreover, the experimental arrangement has enabled the acquisition of images of living cells in suspension with a satisfactory signal-to-background ratio by using only a single pair of laser shots. Therefore, each image can be acquired using a total duration of 3 ns, which is the pulse duration of the laser used in this study. Finally, lack of damage on cells has been demonstrated in conditions leading to strong CARS signal generation. In particular, no cell morphological changes were observed and cell membrane integrity (assessed by trypan blue test) was preserved. Copyright © 2012 John Wiley & Sons, Ltd.

The optoelectronic properties of hexagonal boron-nitride and boron-nitride nanotubes (BNNTs) are investigated by using photoconductivity experiments, associated to photoluminescence excitation analysis. By this way, excitations related to the conduction band of hexagonal boron-nitride have been experimentally determined, as well as the free excitonic level. Multiwalled boron-nitride nanotubes have also been lead by using these methods and the first results suggest some hypotheses about the band gap energy and the nature of the various absorptions, which occur under an UV excitation. These experimental results are presented and discussed and some perspectives are finally suggested.

In this paper we report the fabrication and characterization of single wall carbon nanotube film based devices. Carbon nanotubes (CNT) film is deposited on a silica substrate and usual clean room processes have been used to make Pt-electrodes on top of it and to pattern the CNT film. The obtained devices have been used to measure the evolution of the temperature coefficient of resistance (TCR) as a function of temperature. At room temperature the TCR is –0.2%K-1 and becomes even more important as the temperature goes down. Moreover the optical response in atmospheric band II and band III have been investigated at room temperature showing a variation of the device resistance up to 0.2% for an irradiance of ∼100 mW/cm2 in the 3–5 µm range. Such results are very promising for application of CNT films in bolometers for thermal infrared detection (© 2010 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)

Optical properties of multiwall boron nitride nanotubes are investigated by means of luminescence and absorption spectroscopies. Cathodoluminescence imaging shows that boron nitride nanotubes are highly UV luminescent materials and that the luminescence is located all along the nanotube. In comparison with the related bulk material, hexagonal boron nitride, luminescence and absorption experiments point out the role of excitonic effects in this nanoobject.

The temperature-induced changes in Raman spectra of two BN-based materials: a hexagonal boron nitride and soot with single-wall BN nanotubes, have been measured in temperature range 77-600 K in course of heating in the oven/cryostat cell. A nonlinear temperature dependence of the tangential Raman mode position (being at 1366 cm -1 at room temperature) has been observed for both materials. In the temperature range 350-600 K a linear approximation of the tangential Raman mode shifting was applicable. The measured rates were -0.014 cm -1 /K (for h-BN) and -0.027 cm -1 /K (for the nanotube-containing sample). The effects of the oven and laser heating have been compared. Under the laser heating with the same power density the nanotube-containing soot demonstrated much bigger shifts (up to 30 cm -1 ) than h-BN. The data obtained are useful for in-situ diagnostics of different BN-based phases in course of synthesis.

In situ measurements were executed in the continuous wave CO 2 -laser vaporization synthesis of single-walled carbon nanotubes (SWCNTs). The results were compared with the findings of the ex situ analysis of the product. Different catalysts (Co, Ni, Co/Ni, Ni/Y and Co/Y) were used and the temperature of the target surface (T s ) changed to compare the efficiency of the synthesis process. Our main results are related to the SWCNTs diameter which is depending on T, and on the catalysts nature. The targets containing Y with Co or Ni atoms produce more and larger SWCNTs than Co/Ni targets. The SWCNTs' diameter is seen to increase with T s .