Search

The principle of centrifugal force produced by flowing fluid through the semicircular section of a pipe line is not sufficient to explain the characteristic of the centrifugal force type flow transducer developed from this principle. In this study, a modified form of this flow transducer is developed using a modified force sensing technique. This modified force principle explains the characteristic of the flow transducer to a very good extent. The modified force produced in the modified transducer system is composed of four components namely, centrifugal force, momentum force, damping force and restoring force. These forces produce the identical downward and upward movements of the lever ends of a common balance which is initially made horizontal at zero flow by using similar sensing U‐tube and dummy U‐tube. These movements are sensed by two identical inductive sensors. The static characteristic equation of the prototype unit of the transducer using the modified force sensing technique is derived mathematically in the study. The equation coefficients are calculated from the design parameters and are found to be matched with the same obtained from the average characteristic of repeated experiments performed under the same laboratory environment. Thus the proposed modified model appears to be established. [ABSTRACT FROM AUTHOR]

In the smart-grid paradigm, since distribution systems are controlled by various independent operators, it becomes inevitable for all dispatchers to have a wide-area view of the network for situational awareness and protection. This visualisation is accomplished with the aid of protection (p) type micro-phasor measurement unit (μPMU) installed at the bus of the respective distributed generation (DG). One of the pressing issues with DG's is the concern of inadvertent islanding that disrupts orderly reconnection besides posing hazards to utility workers. In view of this, this study proposes a real-time inadvertent islanding detection by μPMU. The voltage and current phasors obtained from these μPMUs by discrete Fourier transform are further processed by Fortescue transform to compute the angle of sequence components. The absolute angle difference between positive and zero components is used to initiate signal for accomplishing intelligent islanding under islanded condition. The simulation results prove the method to be robust, computationally efficient, non-detection zone free and feasible. Most significantly, as measuring equipment and relay are already present in p type μPMU, therefore unlike other detection methods, no extra arrangements are required in this method making it economically viable and easy to implement. [ABSTRACT FROM AUTHOR]

This paper aims toward the first step for green campus approach for Indian School of Mines ( ISM) campus. Comparative study of the performances for nine different commercialized solar panels made of Maxeon Cell Technology, HIT (Heterojunction with Intrinsic Thin layer), monocrystalline silicon (Mono C-Si), polycrystalline silicon (Poly C-Si), Micromorph, SCHOTT, amorphous silicon (a-Si), CIGS, CdTe technologies in the environmental condition of ISM are presented in this paper. This system suggests to supply the daytime electricity demand of ISM campus as well as efficient use of the huge roof areas of different buildings to setting up the photovoltaic plant. This system ensures a daily mean reduction of 8 MWh electricity consumption from grid. The outcome of this study is that a superior performance is noted for modules made of amorphous silicon technology under the typical temperature variant and dry environmental condition of ISM campus. [ABSTRACT FROM AUTHOR]

In India, due to the high price of cooking gases, people still cook with noncommercial fuels like kerosene and firewood. These cause a lot of health problems and also harm the environment. A clean solution to this problem is to use a solar cooker. A solar cooker suffers from the problem of low utility and hence takes a longer period of time for cooking. To counter this problem and reduce cooking time, the solar cooker is tested with charcoal coated utensil. In this paper, a parabolic‐type domestic solar cooker is tested for the same utensil with and without cost effective thermal coating. It is observed that the effectiveness and efficiency of cooking is considerably increased by using the charcoal coating on the utensil. Considering the economic condition of the people of the selected area, this method provides a cost effective way to increase the cooking effectiveness of the solar cooker and reduce dependency on noncommercial fuels. [ABSTRACT FROM AUTHOR]