Search

To verify the applicability of upstream ribs in film cooling, the present numerical study examines heat transfer characteristics and flow field for ribs located upstream of the film hole. Five ribs including bilaterally truncated ribs, centrally truncated ribs, and continuous ribs are explored with the smooth case at two blowing ratios and fixed crossflow Reynolds number. The results show that the film cooling effectiveness of cases with ribs outperforms the case without rib at a low blowing ratio. Centrally truncated ribs and continuous ribs provide superior cooling effectiveness than bilaterally truncated ribs and smooth cases. The introduction of ribs makes the distribution of the heat transfer coefficient (HTC) uneven after the hole. Among these, centrally truncated ribs increased the HTC, while bilaterally truncated ribs reduce the HTC in the far hole area at a high blowing ratio. It is found that anti‐kidney‐shaped vortex pairs are generated between two adjacent jets for centrally truncated rib cases, while they are generated in front of the jets for bilaterally truncated rib cases. For continuous rib, the impingement of the mainstream gas on the jet leads to a reduction in strength of the kidney‐shaped vortex, which allows the coolant to form a better coverage. [ABSTRACT FROM AUTHOR]

In the current numerical study, the thermal and flow field performance of an array of confined multiple jets with air, water, and water‐Al2O3 nanofluid in the maximum crossflow configuration over the target plate with and without pin fins is investigated. The numerical results are validated with the experimental data; it is found that a reasonable prediction related to heat transfer can be made. For this study, steady‐ state Reynolds‐averaged Navier‐Stokes simulations with the shear‐stress transport k‐ω turbulence model in ANSYS Fluent were performed. The simulations are performed with volumetric concentration ϕ = 0.2% to 3% and the jet's Reynolds number Re = 15 000 to 35 000. In all cases, the jet outlet‐to‐target plate distance Z D/ is 3. It is found that the increase in values of the volumetric concentration of nanoparticles results in a decrease of the Nusselt number and an increase of the convective heat transfer coefficient. This is because there is an increase in thermal conductivity of the working fluid with the increase in the volumetric concentration of nanoparticles for the same Reynolds number. About 81.5% and 89.1% enhancement in the average heat transfer flux values is observed for flat and pin fin‐roughened target plates, respectively, for ϕ = 3%. [ABSTRACT FROM AUTHOR]

A numerical study of a three‐dimensional, turbulent, forced convection flow around a hot cubic block exposed to cross‐flow and an impinging jet is carried out. The standard k‐ε turbulence model is used to study the effects of Reynolds number ratio on the flow and heat transfer. For each value of the Reynolds number of the jet, the Reynolds number ratio is equal to 1, 1.5, and 2. The influence of the channel height and the jet axis location are also examined. The governing equations are solved by using Ansys Fluent software 14.5. Results show that the heat transfer increases with the increase in the Reynolds number ratio. At the top of the cube, better cooling occurs with an increase in the speed of the impinging jet. A reduction in the height of the channel and the displacement of the axis of the jet toward the channel inlet improve the heat transfer. Our simulations are compared with experimental data found in the literature, using different turbulence models. [ABSTRACT FROM AUTHOR]