Search

The study deals with a novel torque derivative control of induction motor drives. The proposed technique is mainly finalised to improve the motor dynamic response regardless of speed operating conditions, ensuring satisfactory values of both motor currents distortion and torque ripple. The core of the discussed approach is a special look-up table, in which the converter voltage space vectors are sorted with respect to their influence on the torque derivative, taking also into account their influence on the flux magnitude. The table is indeed accessed by a desired torque derivative value, obtained by properly processing the output of hysteresis controllers. Moreover, a variable duty-cycle technique is implemented in order to ensure a satisfactory torque ripple in steady-state conditions. The proposed algorithm, suitable for a general multilevel inverter, is numerically tested on a three-level neutral point clamped inverter and its performance are compared with the ones obtained by a traditional direct torque control method based on three speed ranges look-up tables. The control is then validated experimentally by means of a reduced scale laboratory prototype fixing the same condition used for numerical analysis. [ABSTRACT FROM AUTHOR]

This study deals with direct torque control (DTC) of induction motor drives when a multilevel inverter is involved. The proposed control technique is finalised to reduce the amplitude of torque oscillations and to improve the motor dynamic response regardless of operating speed conditions while assuring a satisfactory input current distortion. This is achieved by using a special look-up-table built with a novel approach. The control itself is based on the application in each sampling interval of one or two voltage vectors suitably selected, in order to ensure low electromagnetic torque ripple in steady-state operations and fast dynamic behaviour in transient operations. In the algorithm, the converter voltage vectors selection is carried out by using a novel look-up table whose entry points are computed by means of a specialised relation, starting from the outputs of multilevel hysteresis controllers. The suggested method, suitable for a generic multilevel inverter, is detailed for a neutral point clamped three-level inverter. The proposed algorithm is validated by several numerical results, and compared with a DTC algorithm based on a traditional three-speed range look-up tables. Finally, some experimental results, obtained with a scale laboratory setup, are shown, discussed and compared with the numerical ones. [ABSTRACT FROM AUTHOR]