Search

The development of green, controllable, and simplified pathways for rapid dopamine polymerization holds significant importance in the field of polydopamine (PDA) surface chemistry. In this study, a green strategy is successfully devised to accelerate and control the polymerization of dopamine through the introduction of ozone (O3). The findings reveal that ozone serves as an eco‐friendly trigger, significantly accelerating the dopamine polymerization process across a broad pH range, spanning from 4.0 to 10.0. Notably, the deposition rate of PDA coatings on a silicon wafer reaches an impressive value of ≈64.8 nm h−1 (pH 8.5), which is 30 times higher than that of traditional air‐assisted PDA and comparable to the fastest reported method. Furthermore, ozone exhibits the ability to accelerate dopamine polymerization even under low temperatures. It also enables control over the inhibition–initiation of the polymerization process by regulating the "ON/OFF" mode of the ozone gas. Moreover, the ozone‐induced PDA coatings demonstrate exceptional characteristics, including high homogeneity, good hydrophilicity, and remarkable chemical and mechanical stability. Additionally, the ozone‐induced PDA coatings can be rapidly and effectively deposited onto a wide range of substrates, particularly those that are adhesion‐resistant, such as polytetrafluoroethylene (PTFE). [ABSTRACT FROM AUTHOR]

The current routes to couple dispersive liquid-liquid microextraction with capillary electrophoresis are the evaporation of water immiscible extractants and the back-extraction of analytes. In this study, a new methodology for this combination using water-in-oil microemulsion electrokinetic chromatography coupled with normal stacking mode on-line sample concentration was developed to analyze chlorophenols in water samples. The analytes were extracted with tributyl phosphate and the extractant dilution (3×) was directly injected into an electrophoresis buffer (7.7 cm) containing 5% sodium dodecyl sulfate, 78% 1-butanol, 2% 1-heptane, and 15% sodium acetate solution (pH 8.0). This proposed method is very simple and convenient compared to the conventional procedures. The key parameters affecting separation and concentration were systematically optimized. Under the optimized conditions, dispersive liquid-liquid microextraction contributed an enrichment factor of 45-50, and the overall sensitivity improvement was 312-418-fold. Limits of detection between 1.4 and 3.0 ng/mL and limits of quantification between 4.5 and 10.2 ng/mL were achieved. Acceptable repeatability lower than 3.0% for migration time and 9.0% for peak areas were obtained. The developed method was successfully applied for analysis of the chlorophenols in real water samples. [ABSTRACT FROM AUTHOR]