Search

In this article, we present several organic synthetic way to synthesize a family of five polyaromatic molecules based on a cyclophane core. Our strategies revolves around palado-catalyzed substitution on a [2.2]paracyclophane (pCp) building block. Direct formation of a cyclophane was also employed for two molecules. The polyaromatic nature of the cyclophane library we synthetized made them good fluorophores candidate, we hence performed full photophysical characterization (Absorption, Emission, TCSPC) in different solvent as well as embed in polystyrene films. We evaluate how the cyclophane moiety influence their photo physical properties compared to their corresponding homologues without pCp core, demonstrating greater stoke shift and intramolecular exciplex behavior. The general behavior among cyclophanes was also compared and show solvent dependent properties as well as consistency of the photophysics between toluene and polystyrene matrix., (© 2024 The Authors. ChemistryOpen published by Wiley-VCH GmbH.)

The thermodynamics and kinetics of the complexation reaction between lead ions and the fluorescent sensor Calix-DANS4 are determined to optimize the geometry of the microreactor used for the flow-injection analysis of lead and to tune the working conditions of this microdevice. Under our experimental conditions (pH 3.2, low concentration of Calix-DANS4) the 1:1 Pb(2+)-Calix-DANS4 complex is predominantly formed with a high stability constant (log K(1:1)=6.82) and a slow second-order rate constant (k=9.4×10(4) L mol(-1) s(-1)). Due to this sluggish complexation reaction, the microchannel length must be longer than 130 mm and the flow rate lower than 0.25 mL h(-1) to have an almost complete reaction at the output of the microchannel and a high sensitivity for the heavy metal detection. After determination of the values of the reaction times in our different microdevices, it is possible to simulate the calibration curves for the fluorimetric detection of lead under different conditions. An original method is also presented to determine mixing times in microreactors.

The photophysics of a ditopic receptor of potassium ion consisting of a 1,3-alternate calix[4]biscrown with a merocyanine dye (DCM) inserted into each crown is reported. Thanks to the large difference between the binding affinity for one and two potassium ions, one can find relative total concentrations of ligand and potassium ion at which the 1:1 complex is most predominant with respect to the free ligand and the 2:1 complex whose amounts are a few percents. Investigation of the 1:1 complex by femtosecond transient absorption spectroscopy provides evidence for the ultrafast movement of a potassium ion through the calix[4]arene tube upon excitation at 400 nm of the dye. Phototranslocation occurs in the picosecond timescale with a non-exponential kinetics without competition with photoejection towards the bulk. The translocation time includes two main short components: 0.83 ps and 10 ps. A smaller-weighted third component of 101 ps might include a competition between phototranslocation and excitation energy transfer as shown by using Förster's theory. These findings open the way to new strategies for light-driven molecular shuttles with the aim of information storage and binary logic computing at a nanometric scale.

Photoinduced calcium release from the crown ether-linked merocyanine DCM-crown is reexamined by femtosecond transient absorption spectroscopy with sub-100 fs time resolution. Photodisruption of the bond linking the cation to the nitrogen atom shared by the crown and the chromophore is found to take place in 130 fs. Confirming our previous reports, the photoinduced intraligand charge transfer is observed in the picosecond regime but kinetics involving three-components (1 ps, 8 ps and 77 ps), together with a 56 ps stimulated-emission time-resolved red shift, are found in the present study. Both delayed intraligand charge transfer and cation release are assumed to occur in this time range due to repulsion effects between the positively charged nitrogen of the crown ether moiety and the cation. In the subnanosecond regime, a 670 ps time-resolved red shift of the stimulated-emission spectrum of the charge-transfer state, similar to the shift previously observed with Sr(2+), demonstrates the motion of the cation away from the crown to the bulk. A thorough examination of the present data allows us to conclude that calcium ion is photoejected to the bulk in a multistep process.

The use of a crown-ether-linked merocyanine, DCM-crown, for producing photoinduced, long-lived and reversible concentration jumps of metal cations is reexamined. In this new investigation, the excited-state behavior of DCM-crown complexed with a strontium ion in acetonitrile is found to exhibit the same trends as those previously reported with calcium and lithium ions. However, some new features provide evidence for cation photorelease to the bulk. Subpicosecond transient absorption experiments confirm the initial fast photodisruption of the interaction between the ion and the crown, and the formation of a loose complex after intramolecular charge transfer within the chromophore. Two additional steps are observed. Firstly, a continuous red shift of the gain spectrum is seen on the subnanosecond scale. It is assigned to the movement of the Sr2+ cation away from the chromophore, partly to the bulk of the solvent and partly towards the formation of an ultraloose complex with oxygen atoms of the crown. Secondly, a free-ligand-like absorption remains after the complete decay of the excited state. This band, which signals a total photorelease of the Sr2+ ion, disappears with a characteristic time of about 110 ns, attributed to the recomplexation of the crown in the ground state of the dye.