Search

This paper attempts to present a quasi-3D finite element method technique for modeling and analyzing tubular linear permanent magnet machines (TLPM) with translator eccentricity. Normal tubular linear machines can be modeled effectively using 2D axisymmetric models, but with the introduction of the eccentricity factor into the geometry the axis symmetry is no longer valid, and hence 3D modeling techniques become the only way for studying the machine. However, sometimes 3D modeling can become time-consuming and requires a huge amount of resources especially for non-linear problems, so the interest in modeling techniques that can represent the problem at hand with less computation time and relatively accurate results is high. A quasi-3D technique was specifically developed to be able to represent the eccentricity in TLPMs. The finite element method (FEM) was used for modeling. Eccentricity analysis has been carried on two different TLPM structures using the proposed quasi-3D, and the results from the quasi-3D model were compared to those obtained using the 3D FEM model. Both the open circuit and the on-load operating conditions were studied with the magnetic saturation taken into account. The behavior and the accuracy of the proposed model varied between the two studied structures and for the different operating conditions, and with very low computation time and cost the results obtained from the quasi-3D model were satisfactory in general except for certain cases.

This paper presents the design of a hybrid excited flux switching Vernier machine. This machine is designed to serve in renewable energy conversion applications, such as a wind turbine generator, or tidal turbine generator. After introducing this original structure, a design based on finite element models is conducted. The specifications correspond to relatively low power direct drive wind or tidal turbine applications. The rated power is set to 10 kW, with a rated speed of 300 rpm. Mainly the electromagnetic design is presented. Aspects related to the realization of a prototype are also presented, and an experimental study is included.

The aim of this paper is to present the design and modeling of a machine that possesses some advantageous characteristics for wind energy conversion applications. The studied machine is a double stator inner rotor axial airgap flux switching permanent magnet machine (AFSPM). The paper will start by presenting this type of machine and its points of interest. Then, it will continue by introducing the constructed prototype and its specifications and structure. This prototype has been designed based on a reference specification used at GREAH to develop different prototypes and compare their performances. The second part will introduce the reluctance network model specifically constructed for this type of machine. The constructed model was validated by comparing its results to the results from the finite element method model. Finally, the experimental results will be presented and compared to the reluctance network (RN) model results where satisfying agreement between both results was obtained.