Search

The tensile and dynamic mechanical properties of a nanocomposite, containing modified carbon nanofibers (MCNFs) homogenously dispersed in an elastomeric ethylene/propylene (EP) copolymer semicrystalline matrix (84.3 wt% P), have been correlated with the structure development. These properties were characterized by in situ synchrotron X-ray diffraction during stretching, dynamic mechanical analysis and X-ray analysis techniques over a wide temperature range. Upon sequential drawing, the tensile strength of the nanocomposite film was notably higher than that of the unfilled polymer even though both samples exhibited a similar amount of crystal fraction and the same degree of crystal orientation, revealing the effect of nanofiller reinforcement in the semicrystalline matrix. The mechanical spectra of the 10 wt% MCNF filled samples in both stretched and non-stretched states showed broadening of the elastic modulus at high temperatures, where the corresponding crystallinity index also decreased. It is conceivable that a significant fraction of chain orientation is induced in the vicinity of the nanofillers during stretching, and these stretched chains with reduced mobility significantly enhance the thermal mechanical properties.

The shear‐induced crystallization behavior of isotactic polypropylene (iPP) nanocomposite melt containing modified carbon nanofibers (MCNFs) was investigated by rheo‐SAXS (small‐angle X‐ray scattering) and rheo‐WAXD (wide‐angle X‐ray diffraction) techniques using synchrotron radiation. Under quiescent conditions, the nucleating effect of MCNFs on crystallization of iPP was pronounced and the system exhibited a remarkably low saturation point (ca. 0.05 wt% of MCNF). In‐situ SAXS and WAXD results showed the development of shear‐induced crystalline structures and lamellar morphology in nanocomposite melts. Under the same shear conditions, the filled system exhibited notably faster kinetics compared with the unfilled system. The oriented crystalline fraction was found to decrease with the MCNF loading, indicating the competition between oriented crystals (induced by shear) and unoriented crystals (due to the nucleating effect of MCNF). At the early stages of crystallization, the amount of the oriented crystals increased with the MCNF concentration, suggesting that the nanofiller hindered the motion of polymer chains after the cessation of flow resulting in the delayed relaxation of stretched polymer segments.

Structure and property of a nanocomposite consisting of modified carbon nanofibers (MCNFs), homogenously dispersed in an elastomeric ethylene/propylene (EP) random copolymer (84.3 wt% P) matrix, were studied by in situ synchrotron X-ray diffraction during uniaxial deformation. The MCNF acted as a nucleating agent for crystallization of the α-form of isotactic polypropylene (iPP) in the matrix. During deformation at room temperature, strain-induced crystallization took place, while the transformation from the γ phase to α phase also occurred for both unfilled and 10 wt% MCNF-filled samples. The tensile strength of the filled material was consistently higher than that of pure copolymer. However, when compared with pure copolymer, the highly stretched nanocomposite exhibited a higher amount of unoriented crystals, a lower degree of crystal orientation and a higher amount of γ crystals. This behavior indicated that polymer crystals in the filled nanocomposite experienced a reduced load, suggesting an effective load transfer from the matrix to MCNFs. At elevated temperatures, the presence of MCNFs resulted in a thermally stable physically cross-linked network, which facilitated strain-induced crystallization and led to a remarkable improvement in the mechanical properties. For example, the toughness of the 10 wt% nanocomposite was found to increase by a factor of 150 times at 55 °C.

The isothermal cold crystallization of poly(ethylene naphthalene-2,6-dicarboxylate) was investigated by simultaneous small and wide angle X-ray scattering and dielectric spectroscopy (DS). By this experimental approach, simultaneously collected information was obtained about the specific changes occurring in both crystalline and amorphous phases during crystallization, namely about the chain ordering through wide angle X-ray scattering, about the lamellar crystals arrangement by means of small angle X-ray scattering, and about the amorphous phase evolution by means of DS. The results indicate that average mobility of the amorphous phase suffers a discontinuous decrease upon passing from the primary to the secondary crystallization regime. We interpret these results assuming that the restriction to the mobility of the amorphous phase occurs mainly in the amorphous regions between the lamellar stacks and not in the amorphous regions within the lamellar stacks. © 2002 Elsevier Science Ltd. All rights reserved.

The isothermal crystallization process of poly(ether-ether-ketone) from the glass has been studied in real time by dielectric spectroscopy and x-ray scattering experiments. The combination of these two techniques revealed a complete picture of the crystallization processes from the point of view of both amorphous and crystalline phases. Analysis of results shows that the sample morphology consists of lamellar stacks, separated by rather broad amorphous regions. The lamellar stacks are highly crystalline (~70%), as obtained from both dielectric and x-ray scattering measurements, and the amorphous phase within the stacks is constrained up to a level where no segmental relaxation is possible. The remaining amorphous phase, after completion of the primary crystallization process, still has a certain mobility, but it is significantly slower than the initial amorphous mobility. Dielectric data and x-ray results are found to be highly congruent.

In an attempt to study the specific influence of cross-linking on the (alfa) relaxation in polymer networks, a series of model heterocyclic polymer networks (HPN) with well-defined cross-link densities and constant concentration of dipolar units were studied. Model HPN systems were prepared by simultaneous trimerization of 1,6-hexamethylene diisocyanate (HMDI) and hexyl isocyanate (HI). These HPN systems were characterized by dielectric relaxation spectroscopy in the 10–1 Hz

A novel experimental setup is described which allows one to obtain detailed information on structural and dynamical changes in polymers during crystallization. This technique includes simultaneous measurements of small angle-wide angle x-ray scattering and dielectric spectroscopy (SWD). The capabilities of the technique have been probed by following in real time the crystallization process of a model crystallizable polymer: poly(ethylene terephthalate). By performing these experiments, simultaneous information from both, the amorphous and the crystalline phase is obtained providing a complete description of changes occurring during a crystallization process. The SWD technique opens up new promising perspectives for the experimental study of the relation between structure and dynamics in materials science.