Search

The outdoor low temperature fresh air can be used as a free cold source to eliminate waste heat for the building interior zones during the transition season and winter. This paper takes a project in Hunan as an example, and the project building interior zones is 25m×7m×3.9m(L×W×H). Using Fluent software to simulate the temperature field and velocity field both the interior and exterior zones of the engineering offices. The simulation results show that using the displacement ventilation system to take the outdoor air into inner rooms not only cooling but also improving the air quality and adding comfort. According to the simulation results and outdoor air dry bulb temperature and enthalpy values, the h - d diagram is divided into three air conditioning conditions (summer, winter, transition season), and three different operation adjustment methods have been proposed corresponding to each air conditioning condition, which will reduce the energy consumption of air conditioning system. [ABSTRACT FROM AUTHOR]

Abstract: A retrofit study was conducted in an unoccupied manufactured house to investigate the impacts of airtightening on ventilation rates and energy consumption. This paper describes the retrofits and the results of the pre- and post-retrofit assessment of building airtightness, ventilation, and energy use. Building envelope and air distribution systems airtightness were measured using fan pressurization. Air change rates were measured continuously using the tracer gas decay technique. Energy consumption associated with heating and cooling was monitored through measurement of gas consumption by the forced-air furnace for heating and electricity use by the air-conditioning system for cooling. The results of the study show that the retrofits reduced building envelope leakage by about 18% and duct leakage by about 80%. The reduction in the house infiltration rates depended on weather conditions and the manner in which the heating and cooling system was controlled, but in general these rates were reduced by about one third. The energy consumption of the house for heating and cooling was reduced by only about 10%, which is relatively small but not totally unexpected given that infiltration only accounts for a portion of the heating and cooling load. [Copyright &y& Elsevier]

The generation of heat in buildings, and the way this heat is exchanged with the exterior, plays an important role in urban climate. To analyze the impact on urban climate of a change in the urban structure, it is necessary to build and use a model capable of accounting for all the urban heat fluxes. In this contribution, a new building energy model (BEM) is developed and implemented in an urban canopy parameterization (UCP) for mesoscale models. The new model accounts for: the diffusion of heat through walls, roofs, and floors; natural ventilation; the radiation exchanged between indoor surfaces; the generation of heat due to occupants and equipments; and the consumption of energy due to air conditioning systems. The behavior of BEM is compared to other models used in the thermal analysis of buildings (CBS-MASS, BLAST, and TARP) and with another box-building model. Eventually, a sensitivity analysis of different parameters, as well as a study of the impact of BEM on the UCP is carried out. The validations indicate that BEM provides good estimates of the physical behavior of buildings and it is a step towards a modeling tool that can be an important support to urban planners. [ABSTRACT FROM AUTHOR]