Search

This article presents a 6.78-MHz wireless power transfer (WPT) system, which is configured to automatically cancel the reactance in primary and secondary. In the WPT system, the detuning caused by the parameter variation, the implementation of the frequency control, and components tolerance will decrease a lot the system performance, especially in very low coupling (k = 0.06) and low power applications. The delivered power is sensitive to the reactance under low coupling and high-frequency conditions, accordingly, a novel self-adaptive WPT system to automatically retune the resonance is proposed. The proposed concept uses a synchronous series compensator (SSC) instead of a capacitor in series with the secondary to tune it, which can automatically cancel the reactance caused by the inductor, nonresistive load or frequency variation, hence increases the system performance in terms of delivered power and efficiency. A prototype has been built and tested experimentally to validate the feasibility of the proposed concept. A constant power of 1.8 W can be transmitted with 50% overall efficiency at a coil separation distance of 1.5 cm between the printed-circuit-board transmitter (3 × 3 cm2) and receiver (1 × 2 cm2) under wide detuning conditions, being 0.95 the ratio between distance and the equivalent diameter of receiver. [ABSTRACT FROM AUTHOR]

The nonlinear and linear controls proposed by Alou and Soto provide very fast transient response (voltage step from 1 to 1.5 V in 2 \mu\s). This nonlinear control is based on hysteretic control of Cout current. This system is very sensitive to effects, like aging, temperature, input and output voltage variation, etc., that modify the switching frequency. This paper proposes a frequency loop to avoid the frequency variation and to adjust the switching frequency to the nominal value by changing the hysteretic band. A 5-MHz buck converter is developed, and experimental results validate the loop design, obtaining the same fast transient response (from 1.5 to 2.5 V in 2 \mu\s) while keeping switching frequency constant in steady state. [ABSTRACT FROM AUTHOR]

This article presents a control linearization technique for a single-phase single-stage inverter with multiple modulation strategies. The power topology is based on an flying capacitor multi-level (FCML) inverter, and the control is based on the plant inversion. The proposed technique allows decoupling the control of the input current and the output voltage, which simplifies the control in two ways: first, the control of both variables is independent and second, the controllers are independent of the modulation applied, thanks to the plant inversion. This control is implemented in an field-programmable gate array. Since the converter operates at variable frequency, two different data acquisition alternatives are explored: sampling at variable frequency (once per switching cycle) or sampling at constant frequency (higher than the switching frequency).The proposed control is validated by simulation and experimental results with a 1-kVA prototype. [ABSTRACT FROM AUTHOR]

V2Ic control provides very fast dynamic performance to the Buck converter both under load steps and under voltage reference steps. However, the design of this control is complex since it is prone to subharmonic oscillations and several parameters affect the stability of the system. This paper derives and validates a very accurate modeling and stability analysis of a closed-loop V2Ic control using the Floquet theory. This allows the derivation of sensitivity analysis to design a robust converter. The proposed methodology is validated on a 5-MHz Buck converter. The work is also extended to V2 control using the same methodology, showing high accuracy and robustness. The paper also demonstrates, on the V2 control, that even a low bandwidth-linear controller can affect the stability of a ripple-based control. [ABSTRACT FROM AUTHOR]