Search

We report on the performance of a 1-V dc programmable Josephson voltage standard (PJVS) operating on a commercially available Gifford-McMahon cryocooler at 4 K. The NIST-fabricated niobium superconductor-normal metal-superconductor junction chip has been shown to operate successfully as integrated with this cryopackage, generating 1.229 V at the maximum operating frequency of 19.364 GHz with Shapiro steps at constant voltage that are flat to within less than 100 nV. Because of the large operating margin (greater than 1 mA), these steps were highly stable and immune from noise. Differences in behavior of the PJVS in liquid helium and on the cryocooler are discussed. This demonstration paves the way towards automated warming and cooling of the Josephson device and a fully automated voltage standard system. [ABSTRACT FROM AUTHOR]

Packaging of a superconducting electronic system on a compact multistage cryocooler requires careful management of thermal loads from input and output leads, in order not to exceed the heat lift capacity of the various stages of the cooler. In particular, RSFQ systems typically require a large total bias current Ib ∼ 1 A or greater. A general analysis of resistive wires shows that the tradeoff between heat flow and Joule heating yields a minimum heat load Qmin from optimized bias leads on a Iow-T stage, given by Qmin [0.3 mW/(A - K)]ThotIb, where Thot is the thermalization temperature of the leads on the previous (hotter) stage. This is independent of the material, number, and geometry of the leads, as long as the total lead resistance is optimized. A similar tradeoff between heat flow and signal attenuation can be applied to the optimization of high-frequency input/output lines. Superconducting leads are not subject to these limitations, and can result in further reduction in heat load. Design examples are presented for an RSFQ-based radio receiver on either a two-stage or a four-stage cooler. [ABSTRACT FROM AUTHOR]