Search

In the long-term electricity generation and driving sensor work process of marine sediment microbial fuel cells(MSMFCs), its cathode in the seawater may be embedded into the marine sediment, which will affect the electrochemical performance and lead to MSMFCs failure. The article simulated the embedding ratio of cathodes in sediment in the laboratory: 1/3, 1/2, 2/3, in order to investigate the changes of the electrochemical performance of the cathode and the electricity generation performance of MSMFCs. The results show that: the open circuit potential dropped and the required longer steady time with the higher embedding ratio of the cathode. Its capacitance decreased gradually, and the minimum capacitance was 32 F/cm2 (2/3 group), which was 0.72 times of the Blank. The kinetic activity decreased firstly and then increased, and its maximum activity was 1.61 times of the Blank (2/3 group); The maximum power density of the MSMFCs was 140.83 mW/m2 (1/3 group), which was 1.21 times of the Blank. With the increase of embedding ratio of the cathode in the marine sediment, its electrochemical performance and electricity generation performance of MSMFCs both fluctuates, but the normal operation of MSMFCs can still be ensured.

As a metal additive manufacturing process, laser cladding (LC) is employed as a novel and beneficial repair technology for damaged steel structures. This study employed LC technology with 316 L stainless steel powder to repair locally corroded steel plates. The influences of interface slope and scanning pattern on the mechanical properties of repaired specimens were investigated through tensile tests and finite element analysis. By comparing the tensile properties of the repaired specimens with those of the intact and corroded specimens, the effectiveness of LC repair technology was assessed. An analysis of strain variations in the LC sheet and substrate during the load was carried out to obtain the cooperation mechanism between the LC sheet and substrate. The experimental results showed that the decrease in interface slope slightly improved the mechanical properties of repaired specimens. The repaired specimens have similar yield strength and ultimate strength to the intact specimens and better ductility as compared to the corroded specimen. The stress–strain curve of repaired specimens can be divided into four stages: elastic stage, substrate yield-LC sheet elastic stage, substrate hardening-LC sheet elastic stage, and plastic stage. These findings suggest that the LC technology with 316 L stainless steel powder is effective in repairing damaged steel plates in civil engineering structures and that an interface slope of 1:2.5 with the transverse scanning pattern is suitable for the repair process. [ABSTRACT FROM AUTHOR]