Search

The hydrosilylation reaction, describing the addition of Si-H bonds to unsaturated bonds, is performed in the presence of catalysts, usually highly active platinum catalysts. This work focuses on the study of a photoinduced hydrosilylation by the use of benzophenone which promotes the addition reaction of olefin on different hydrosilanes. The reactivity of silanes towards addition onto the double bond during hydrosilylation appears to depend on their structure. It was observed that the consumption of Si-H and C[double bond, length as m-dash]C functional groups increases with the irradiation time, and reaches a maximum of approx. 51% in the case of diphenylsilane. The hydrosilylation products are determined with 1 H NMR, HSQC, DEPT, COSY and 13 C NMR. The main product corresponds to the single adduct of the silyl radical onto the double bond. Substitution of the Si-H bond by two or three phenyls groups (triphenylsilane, diphenysilane) enhances the yield of the reaction, although diphenylsilane was found to be more efficient than triphenylsilane because of its lower steric hindrance. The ketyl radical formed after hydrogen abstraction by the triplet state of benzophenone likely forms benzopinacol, a reaction which reduces the overall yield of the hydrosilylation reaction. All these experiments are in line with DFT calculations of the Gibbs free energy of the reactions involved. This sheds new light on the photoinduced hydrosilylation process and opens the way to more active combinations of photoinitiator/silane/vinylsilane systems., Competing Interests: There are no conflicts to declare., (This journal is © The Royal Society of Chemistry.)

Base catalyst and oxidant are usually necessary to promote the polymerization of poly(disulfide) oligomers through oxidative coupling of the terminal SH groups into S-S bonds. In this study, we prove that self-polymerization of bifunctional (disulfide) oligomer films can take place in a matter of minutes under UVC irradiation (254 nm, 10.5 mW cm -2 ). The resulting insoluble polymer is characterized using solid-state NMR, 1 H T 2 NMR relaxation measurements, thermal analysis, and Fourier-transform infrared spectroscopy and proves to have similar composition as a model poly(disulfide) prepared under oxidative conditions, but distinct physical properties. These differences are explained by a change in polymer architecture due to a higher ratio of cyclization relative to linear polymerization. Homolytic photocleavage of internal S-S bonds creates thiyl groups close to each other, driving an increased kinetic feasibility for the cyclization reaction by radical coupling. The subsequent formation of mechanically interlocked macrocycles (polycatenane network) is proposed to account for film properties analogous to those of a cross-linked polymer., Competing Interests: The authors declare no competing financial interest.

We report on the synthesis and the photophysical properties of a trans-nitroalkoxystilbene dimer (DPNS). The fluorescence quantum yield (Φ(f)), the Stokes shift, and the quantum yield for the trans-to-cis photoisomerization (Φ(t→c)) are strongly dependent on the nature of the solvent. Upon increasing solvent polarity, Φ(f) increases together with the decrease of Φ(t→c). This solvent-induced reverse behavior mainly stems from the progressive stabilization of a highly polar twisted internal charge transfer state (TICT) at excited singlet level which opens a competing channel to photoisomerization. In the presence of hydroxylic substrates (i.e., alcohols or water), fluorescence of DPNS is strongly quenched due to a hydrogen bonding interaction at excited state. The efficiency of the process is clearly correlated to the H-bond donor ability of the quencher. In aqueous solution, the major formation of a 2:1 host-guest complex with β-cyclodextrins (β-CD) prevents the quenching by H(2)O and leads to a 50-fold increase of the fluorescence signal together with a strong band blue-shift with respect to that of the free chromophore. This latter effect was rationalized in terms of a severe reduction of the solvent-induced stabilization of the TICT state. As a consequence, the trans-to-cis photoisomerization reaction is reactivated and leads to a paradoxical 14-fold increase of Φ(t→c) even though DPNS is sequestered in β-CD cavities.

Photoacid-catalyzed sol-gel polymerization is now recognized as a powerful single-step synthetic approach to the synthesis of hybrid films, which can be distinguished from conventional sol-gel methods by higher reactivity and a solvent-free process. Despite its utility, the mechanism is not yet understood, in particular what chemical, physical, and photochemical parameters determine the precise sequence, kinetics, and advancement of this UV inorganic photopolymerization. Here, using mainly transmission real-time Fourier transformed infrared (RT-FTIR) spectroscopy, we characterize in situ the hydrolysis-condensation reactions of oligomeric silicon alkoxides and the formation of byproducts. Systematic review and assessment of numerous processing variables (relative humidity, film thickness, precursor structure, nature, and the concentration of photoacid generator) prove that the reaction kinetics are controlled by the two independent phenomena: the intrinsic chemical reaction rates and the water vapor permeation into the film.

[reactions: see text] The stereoselective outcome of Pd(II)- or Ag(I)-catalyzed intramolecular N-alkylation to afford 1,3-disubstituted 1,2,3,4-tetrahydroisoquinolines was examined. In the absence of additional substituents, Pd(II) allows a facile access to the cis isomers, while Ag(I) favors formation of the trans isomers. The same observation was made for the synthesis of 2,5-disubstituted pyrrolidines. Possible reasons for the observed stereoselectivities are discussed.