Search

Addressing strongly interacting matter in the region of energy density where the hadronic gas phase coexists with the quark-gluon plasma phase, we discuss how thermodynamic consistency can be used to constrain the equation of state for uniform matter and we illustrate the method by constructing a T_c-dependent family of thermodynamically consistent equations of state based on simple spline interpolations between the gas and plasma phases.

Electromagnetic design of a moving magnet frictionless linear actuator with self-holding functionality for mechanical gear shifting in a transmission application is presented. The actuator consists of a tubular magnetic circuit with stationary armature and axially moving rotating permanent magnet assembly with radial magnetisation in the air gap. The armature contains a two-piece magnetic core with a space for a winding. The effects of armature slot opening and magnetic circuit materials on the self-holding force and the acting force are studied in the whole moving range. The designed moving magnet linear actuator improves the performance of the vehicle by enabling shift times below 50 ms with no energy consumption between the shifts. [ABSTRACT FROM AUTHOR]

Mechanical interactions between a wind turbine and a direct-driven permanent-magnet synchronous generator (PMSG) are studied, and a model to analyze the system behavior is suggested. The proposed model can be applied to analyze the mechanical vibrations of direct-driven wind turbine installations both in steady state and in dynamic cases. The cogging torque and torque ripple of the PMSG are used as excitation sources in the mechanical model. Four different permanent-magnet rotor constructions are analyzed. It is shown that the maximum allowable value of the cogging torque of the direct-driven permanent-magnet wind generator in this case is 1.5%–2% of the rated torque even when the corresponding resonance frequency does not occur in the operational speed range of the wind turbine. Furthermore, it was noticed that the resonance caused by the excitation torque should occur at the lowest possible speed. [ABSTRACT FROM AUTHOR]

In the present research work, an electrical resistance tomography (ERT) system is utilized as a means for real-time fault detection and diagnosis (FDD) during a reactive crystallization process. The calcium carbonate crystallization is part of the carbon capture and utilization scheme where process monitoring and malfunction diagnostics strategies are presented. The graphical logic representation of the fault tree analysis methodology is used to develop the system failure states. The measurement consistency due to the use of a single electrode from a set of ERT electrodes for malfunction identification is experimentally and quantitatively investigated based on the sensor sensitivity and standard deviation criteria. Electrical current measurements are employed to develop a LabVIEW-based process automation program by using the process-specific knowledge and historical process data. Averaged electrical current is correlated to the mechanical failure of the stirrer through standard deviation evaluation, and slopes of the measured data are used to monitor the pump and concentrations status. The performance of the implemented methodology for detecting the induced faults and abnormalities is tested at different operating conditions, and a basic signal-based alarming technique is developed. [ABSTRACT FROM AUTHOR]