Search

The Middle Permain Maokou Formation (P2m) is a new region of natural gas exploration in the Sichuan Basin, is characterized by bioclastic limestone with localized dolomitization, and karst fractured-vuggy reservoirs. Currently, on the gas source, hydrocarbon accumulation process and control factors in the Sichuan Basin during the Permian are lacking. To bridge this gap, herein, we identified the filling sequence minerals inside the pores/vugs, along with the oil charge of the Maokou Formation using drill cores, thin sections, oil inclusion analysis, and U-Pb dating of calcite cements. The results showed that the reservoir space of the Maokou Formation was predominated by the residual dissolved pores/vugs, fractures, and dissolved fractures. The pores/vugs underwent four stages of mineral filling by very fine-fine (-crystalline, CC1) calcite ^ fine-medium calcite (CC2: from 256.4 ± 1.7 to 244.1 ± 6.3 Ma) ^ fibrous calcite (FC; -183.9 ± 8.2 Ma) ^ coarse-macro calcite (CC3; -171.5 ± 5.3 Ma). Combined with the homogenization temperature and salty of fluid inclusion, we considered that three stages of oil charge were present in the Maokou Formation reservoirs. The first stage involved the formation of paleo-oil reservoirs during the Late Permian to Early Triassic, corresponding to the high-maturity aqueous inclusions in CC2, with a homogenization temperature of 106.7°C-137.8°C. At that time, the oil generation from the Lower Cambrian Qiongzhusi Formation rocks peaked, and the generated hydrocarbons migrated upward into the Maokou Formation through the strike-slip faults in the basin center. The second stage involved the formation of paleo-oil reservoirs during the Early Jurassic. The Permian source rocks reached the oil generation window with hydrocarbon expulsion, which was consistent with the oil inclusions in FC. The third stage involved the formation of paleo-gas reservoirs during the Middle Jurassic to Early Cretaceous, corresponding to the high-density methane inclusions and bitumen inclusions occurring in CC3, with the homogenization temperature peaking at 151.9°C-178°C. The natural gas in the Middle Permian of the Central Sichuan Basin is predominantly sourced from the Lower Cambrian Qiongzhusi Formation mudstone and partially from the source rocks of the Middle Permian, indicating a significant source-reservoir conduit of the strike-slip faults in the basin center. The findings provide considerable baseline data to advance further research in the Sichuan Basin. [ABSTRACT FROM AUTHOR]

Shale reservoirs contain petroleum that undergoes losses through oil expulsion and evaporation, with uncertain implications on shale oil reserves and mobility evaluation. This study focuses on understanding the influence of these losses on open‐system pyrolysis, the primary method for assessing shale oil content and mobility. Comprehensive analyses were performed on 26 lacustrine shale samples from the Chang7 Member, encompassing total organic carbon (TOC), programmed pyrolysis, solvent extraction, and gas chromatography–mass spectrometry (GC–MS). The research examines the impact of petroleum losses on petroleum fractions, the oil saturation index (OSI), and multi‐step pyrolysis outcomes. The findings indicate that Chang7 shale with TOC content above 7% experiences more substantial petroleum losses than those with TOC below 7%. Petroleum losses result in significant fractional distillation of crude oil in the shale, leading to the deterioration of shale oil properties and a notable reduction in free oil content in S1, ultimately causing a decline in OSI values. As a result, Chang7 shale with TOC below 7% demonstrates a higher potential for shale oil recovery, whereas Chang7 shale with TOC exceeding 7% should be considered more significant as a hydrocarbon source rock. Moreover, multi‐step pyrolysis is not suitable for assessing petroleum mobility in shale with low free oil content (OSI values below 100 mg/g). This limitation arises from the loss of free low‐boiling components in Chang7 shale, and the currently detected low‐boiling pyrolysis products may predominantly exist in an adsorbed state. [ABSTRACT FROM AUTHOR]

Ultra‐deep Sinian carbonate rocks are rich in natural gas, and the Deng‐4 Member of the Central Sichuan Basin has been shown to have an extremely high degree of thermal evolution. They are characterized by dry gas produced due to the thermal cracking of palaeo‐oil reservoirs (PORs). The distribution of PORs as materials for the formation of cracked gas reservoirs remains unclear. The complex multistage evolution process and limited drilling data make it challenging to precisely and systematically recover a range of PORs. Based on basin and petroleum system modelling (BPSM), the bottom‐up migration and accumulation method was used to investigate the distribution of PORs. Research shows that the PORs in the Sinian Deng‐4 Member were mainly formed in the Early–Middle Triassic under the mixed contribution of Cambrian and Sinian source rocks, and the coupling of palaeostructural and trap settings controlled its accumulation. Generally, the distribution of PORs can be divided into two categories: one is located at the core of the uplift zone and is controlled by structural‐stratigraphic composite traps, whereas the other is controlled by a series of lithologic traps formed in the slope area. Sensitivity analysis showed that the distribution patterns of the PORs were mostly related to the facies conditions (physical characteristics) of the reservoirs. The widely distributed PORs provide necessary and sufficient material conditions for the formation of cracked Sinian gas reservoirs in the Central Sichuan Basin, and the North Slope area has great potential for natural gas exploration in the future. [ABSTRACT FROM AUTHOR]