Search

In this study, the relationship between the properties of the wood and kraft pulp fibers as well as paper characteristics of 27-year-old trees, lodgepole pine (Pinus contorta) and Scots pine (Pinus sylvestris), was assessed. All trees had been grown in Latvia, within the same forest type, Myrtillosa. Wood density, year ring width, chemical composition and cross-sectional cell wall dimensions were measured. Fiber characteristics were determined, and handsheets were made for all samples from unbeaten kraft pulp. The results showed that the amount of latewood had a positive correlation with wood density for both species and with further positive impact on the paper burst index. Also, slight differences in cross-sectional dimensions were observed. Lodgepole pine provided paper with higher burst strength than Scots pine. Since the former is of higher density, less wood per volume is needed to produce a ton of pulp, and results showed a higher pulp yield in the case of lodgepole pine. [ABSTRACT FROM AUTHOR]

The objective of the present study was to investigate the interaction between Cu-containing preservatives and birch (Betula spp.) and pine (Pinus sylvestris L.) wood, modified at a relatively mild temperatures (150 - 180°C). The disposition of wood to absorb water was evaluated by capillary absorption (CA) tests through the specimens' tangential and radial surface. Changes in wood drying characteristics due to thermal modification (TM) were evaluated by monitoring wood moisture dynamics after impregnation. In order to assess the capacity of wood to absorb preservatives, a vacuum/pressure process was used to impregnate small specimens for which uniform saturation into the entire volume can easily be reached. Quantitative determination of copper Cu content in the specimens was performed by using atomic absorption spectroscopy (AAS). The fixation of the absorbed Cu was evaluated by subjecting the specimens to leaching procedures according to EN 84 and assessing the ratio of retained Cu in the specimens. The CA test showed deceleration of capillary absorption in TM birch wood through both surfaces, with similar absorption rates regardless of treatment temperatures. A significant increase in the absorption rate through the tangential surface was recorded for TM pine wood and the increase was greater for specimens treated at higher temperatures. The results of moisture content monitoring showed a similar reduction in the drying rate due to thermal modification regardless of species. Comparing wood of one species with similar densities, less preservative was absorbed by TM wood. However, the results of AAS showed that, in comparison with unmodified wood, 10% (birch) and 25% (pine) more Cu per one gram of wood was introduced during impregnation. Nevertheless, TM also resulted in higher Cu leaching rates for both species. [ABSTRACT FROM AUTHOR]