Search

Background: Orthopedic footwear is often prescribed to improve postural stability during standing and walking in individuals with Hereditary Motor Sensory Neuropathy. However, supporting evidence in literature is scarce. The aim of this study was to investigate the effect of orthopedic footwear on quiet standing balance, gait speed, spatiotemporal parameters, kinematics, kinetics and dynamic balance in individuals with Hereditary Motor Sensory Neuropathy.Methods: Fifteen individuals with Hereditary Motor Sensory Neuropathy performed a quiet standing task and 2 -min walk test on customized orthopedic footwear and standardized footwear. Primary outcome measures were the mean velocity of the center of pressure during quiet standing and gait speed during walking. Secondary outcome measures included center of pressure amplitude and frequency during quiet standing, and spatiotem-poral parameters, kinematics, kinetics, and dynamic balance during walking. Two-way repeated measures ANOVA and paired t-tests were performed to identify differences between footwear conditions.Findings: Neither quiet standing balance nor dynamic balance differed between orthopedic and standardized footwear, but orthopedic footwear improved spatiotemporal parameters (higher gait speed, longer step length, shorter step time and smaller step width) during walking. Moreover, less sagittal shank-footwear range of mo-tion, more frontal shank-footwear range of motion, more dorsiflexion of the footwear-to-horizontal angle at initial contact and more hip adduction during the stance phase were found.Interpretation: Orthopedic footwear improved walking in individuals with Hereditary Motor Sensory Neuropathy, whereas it did not affect postural stability during quiet standing or dynamic balance. Especially gait speed and spatiotemporal parameters improved. An improved heel landing at initial contact for all footwear and reduced foot drop during swing for mid and high orthopedic footwear contributed to the gait improvements wearing orthopedic footwear. This study is part of the GaReC project, which is co-funded by OIM Orthopedie and the PPP Allowance made available by Health ~ Holland, Top Sector Life Sciences & Health, to stimulate public-private partnerships. The authors would like to thank all participants for their participation, Bart Nienhuis for his technical support and Evi van Grinsven for her contribution to data collection.

Purpose: To investigate the effects of a systematic tuning protocol for ankle foot orthosis footwear combinations (AFO-FC) using incrementing heel height on gait in children with cerebral palsy (CP). Methods: Eighteen children with CP (10.8 ± 3 years, Gross Motor Function Classification System (GMFCS) I–II) underwent 3D gait analysis on a treadmill, while the AFO heel surface was systematically incremented with wedges. Children were subdivided based on their gait pattern, i.e., knee hyperextension (EXT) and excessive knee flexion (FLEX). Outcome measures included sagittal hip and knee angles and moments, shank to vertical angle (SVA), foot to horizontal angle, and gait profile score (GPS). Results: For both groups, incrementing heel height resulted in increased knee flexion, more inclined SVA, and increased knee extension moments. This resulted in gait improvements for some children of the EXT-group, but not in FLEX. High variation was found between individuals and within-subject effects were not always consistent for kinematic and kinetics. Conclusions: A systematic AFO-FC tuning protocol using incremented heel height can be effective to improve gait in children with CP walking with EXT. The current results emphasise the importance of including kinematics as well as kinetics of multiple instances throughout the gait cycle for reliable interpretation of the effect of AFO tuning on gait.Implications for rehabilitation A systematic ankle foot orthosis footwear combinations (AFO-FC) tuning protocol using incremented heel height can improve gait in children walking with knee hyperextension. Tuning results in changes throughout the gait cycle. Little evidence is found for an optimal SVA of 10–12° at midstance. For clinical interpretation, both joint kinematic and kinetic parameters should be considered throughout the gait cycle and evaluation should not be based on SVA only.

Objective Hand orthoses are often prescribed for persons with chronic hand and wrist impairments. This study assessed the feasibility, in terms of production time and user satisfaction, of 3-dimensional printed hand orthoses compared with conventional hand orthoses for this population. Methods In this prospective case series, both a conventional hand orthosis and a 3-dimensional printed hand orthosis were manufactured for 10 participants. Production time (in minutes) of each orthosis was recorded. Each orthosis was worn for one week, after which participants completed a self-designed questionnaire on satisfaction, scored on a 5-point Likert scale. Functionality and orthosis preference were also assessed. Results The mean (standard deviation (SD)) production time for the 3-dimensional printed orthoses, of 112 (11.0) min, was significantly shorter compared with 239 (29.2) min for the conventional orthoses (95% confidence interval (95% CI) 71–182 min, p = 0.001). Satisfaction scores were similar for both orthoses, except for comfort item “fitting method”, which was rated significantly higher for scanning compared with casting (median [IQR] score: 5 [0.0]; 4 [2.0], p = 0.034). Functionality and orthosis preference were rated similar for both orthoses. CONCLUSION As the production time was halved, user satisfaction similar, and scanning experienced as slightly more comfortable than casting, 3-dimensional printed hand orthoses seem feasible and potentially beneficial for use in people with chronic hand and wrist impairments. LAY ABSTRACT Persons with chronic hand and wrist impairments often use an orthosis to make it easier to perform daily activities. Three-dimensional scanning and printing can facilitate the manufacturing of hand orthoses. This study compared 3-dimensional printed orthoses with conventional orthoses for persons with chronic hand and wrist impairments, with regard to production time and user satisfaction. Ten participants used a 3-dimensional printed orthosis, as well as a conventional orthosis, each for one week. The results showed that production time of 3-dimensional printed orthoses was half that of conventional orthoses. Satisfaction with both orthoses was similar, except for the “fitting method”, whereby fitting by 3-dimensional scanning was perceived as slightly more comfortable compared with conventional casting. Functionality and orthosis preference were rated similar for both orthoses. In conclusion, 3-dimensional printed orthoses appear to be a potential treatment option for persons with chronic hand and wrist impairments.

Previous research showed that an Inertial Measurement Unit (IMU) on the anterior side of the shank can accurately measure the Shank-to-Vertical Angle (SVA), which is a clinically-used parameter to guide tuning of ankle-foot orthoses (AFOs). However, in this context it is specifically important that differences in the SVA are detected during the tuning process, i.e., when adjusting heel height. This study investigated the validity of the SVA as measured by an IMU and its responsiveness to changes in AFO-footwear combination (AFO-FC) heel height in persons with incomplete spinal cord injury (iSCI). Additionally, the effect of heel height on knee flexion-extension angle and internal moment was evaluated. Twelve persons with an iSCI walked with their own AFO-FC in three different conditions: (1) without a heel wedge (refHH), (2) with 5 mm heel wedge (lowHH) and (3) with 10 mm heel wedge (highHH). Walking was recorded by a single IMU on the anterior side of the shank and a 3D gait analysis (3DGA) simultaneously. To estimate validity, a paired t-test and intraclass correlation coefficient (ICC) between the SVAIMU and SVA3DGA were calculated for the refHH. A repeated measures ANOVA was performed to evaluate the differences between the heel heights. A good validity with a mean difference smaller than 1 and an ICC above 0.9 was found for the SVA during midstance phase and at midstance. Significant differences between the heel heights were found for changes in SVAIMU (p = 0.036) and knee moment (p = 0.020) during the midstance phase and in SVAIMU (p = 0.042) and SVA3DGA (p = 0.006) at midstance. Post-hoc analysis revealed a significant difference between the ref and high heel height condition for the SVAIMU (p = 0.005) and knee moment (p = 0.006) during the midstance phase and for the SVAIMU (p = 0.010) and SVA3DGA (p = 0.006) at the instant of midstance. The SVA measured with an IMU is valid and responsive to changing heel heights and equivalent to the gold standard 3DGA. The knee joint angle and knee joint moment showed concomitant changes compared to SVA as a result of changing heel height.

Introduction Rigid Ankle-Foot Orthoses (AFOs) are commonly prescribed to counteract excessive knee flexion during the stance phase of gait in children with cerebral palsy (CP). While rigid AFOs may normalize knee kinematics and kinetics effectively, it has the disadvantage of impeding push-off power. A spring-like AFO may enhance push-off power, which may come at the cost of reducing the knee flexion less effectively. Optimizing this trade-off between enhancing push-off power and normalizing knee flexion in stance is expected to maximize gait efficiency. This study investigated the effects of varying AFO stiffness on gait biomechanics and efficiency in children with CP who walk with excessive knee flexion in stance. Fifteen children with spastic CP (11 boys, 10±2 years) were prescribed with a ventral shell spring-hinged AFO (vAFO). The hinge was set into a rigid, or spring-like setting, using both a stiff and flexible performance. At baseline (i.e. shoes-only) and for each vAFO, a 3D-gait analysis and 6-minute walk test with breath-gas analysis were performed at comfortable speed. Lower limb joint kinematics and kinetics were calculated. From the 6-minute walk test, walking speed and the net energy cost were determined. A generalized estimation equation (p

Background Ankle-Foot-Orthoses with a ventral shell, also known as Floor Reaction Orthoses (FROs), are often used to reduce gait-related problems in children with spastic cerebral palsy (SCP), walking with excessive knee flexion. However, current evidence for the effectiveness (e.g. in terms of walking energy cost) of FROs is both limited and inconclusive. Much of this ambiguity may be due to a mismatch between the FRO ankle stiffness and the patient’s gait deviations. The primary aim of this study is to evaluate the effect of FROs optimised for ankle stiffness on the walking energy cost in children with SCP, compared to walking with shoes alone. In addition, effects on various secondary outcome measures will be evaluated in order to identify possible working mechanisms and potential predictors of FRO treatment success. Method/Design A pre-post experimental study design will include 32 children with SCP, walking with excessive knee flexion in midstance, recruited from our university hospital and affiliated rehabilitation centres. All participants will receive a newly designed FRO, allowing ankle stiffness to be varied into three configurations by means of a hinge. Gait biomechanics will be assessed for each FRO configuration. The FRO that results in the greatest reduction in knee flexion during the single stance phase will be selected as the subject’s optimal FRO. Subsequently, the effects of wearing this optimal FRO will be evaluated after 12–20 weeks. The primary study parameter will be walking energy cost, with the most important secondary outcomes being intensity of participation, daily activity, walking speed and gait biomechanics. Discussion The AFO-CP trial will be the first experimental study to evaluate the effect of individually optimised FROs on mobility and participation. The evaluation will include outcome measures at all levels of the International Classification of Functioning, Disability and Health, providing a unique set of data with which to assess relationships between outcome measures. This will give insights into working mechanisms of FROs and will help to identify predictors of treatment success, both of which will contribute to improving FRO treatment in SCP in term. Trial registration This study is registered in the Dutch Trial Register as NTR3418.