Search

A promising liquid killed multivalent whole-cell plus enterotoxin B-subunit oral vaccine against enterotoxigenic Escherichia coli (ETEC), the primary cause of diarrhea among children in low-income countries and travelers to these areas, has recently been developed and tested in preclinical and phase-I and phase-II clinical studies. The vaccine contains killed E. coli bacteria over-expressing the main ETEC colonization factors (CFs) CFA/I, CS3, C5 and C6, and a recombinant enterotoxin B subunit protein (LCTB A ) given together with a recently developed enterotoxin-derived adjuvant, dmLT. A dry-powder vaccine formulation should be advantageous especially for use in low-income countries. Here we describe a method to produce a dry-powder formulation by freeze-drying of the vaccine using inulin as stabilizer. Although not completely preventing aggregation of bacteria during freeze-drying, the stabilizer provided both improved overall bacterial morphology and almost complete recovery of the CF and B subunit antigens. Most importantly, oral-intragastric immunization of mice with the freeze-dried vaccine together with dmLT adjuvant elicited strong intestinal mucosal and serum antibody responses against all vaccine antigens, which were comparable to those achieved with the liquid vaccine. Our results indicate the feasibility to use freeze-drying with inulin as stabilizer for preparing a dry-powder formulation of the novel ETEC vaccine with retained oral-mucosal immunogenicity compared to the liquid formulation. [ABSTRACT FROM AUTHOR]

Abstract: We investigated how the Bradford assay for measurements of protein released from a drug formulation may be affected by a concomitant release of a pharmaceutical polymer used to formulate the protein delivery device. The main result is that polymer-caused perturbations of the Coomassie dye absorbance at the Bradford monitoring wavelength (595nm) can be identified and corrected by recording absorption spectra in the region of 350–850mm. The pharmaceutical polymers Carbopol and chitosan illustrate two potential types of perturbations in the Bradford assay, whereas the third polymer, hydroxypropylmethylcellulose (HPMC), acts as a nonperturbing control. Carbopol increases the apparent absorbance at 595nm because the polymer aggregates at the low pH of the Bradford protocol, causing a turbidity contribution that can be corrected quantitatively at 595nm by measuring the sample absorbance at 850nm outside the dye absorption band. Chitosan is a cationic polymer under Bradford conditions and interacts directly with the anionic Coomassie dye and perturbs its absorption spectrum, including 595nm. In this case, the Bradford method remains useful if the polymer concentration is known but should be used with caution in release studies where the polymer concentration may vary and needs to be measured independently. [Copyright &y& Elsevier]