Search

Accurate identification of species from timber is an essential step to help control illegal logging and forest loss. However, current approaches to timber identification based on morphological and anatomical characteristics have limited species resolution. DNA barcoding is a proven tool for plant species identification, but there is a need to build reliable reference data across broad taxonomic and spatial scales. Here, we construct a species barcoding library consisting of 1550 taxonomically diverse timber species from 656 genera and 124 families, representing a comprehensive genetic reference data set for Chinese timber species and international commercial traded timber species, using four barcodes (rbcL, matK, trnH-psbA, and ITS2). The ITS2 fragment was found to be the most efficient locus for Chinese timber species identification among the four barcodes tested, both at the species and genus level, despite its low recovery rate. Nevertheless, the barcode combination matK+trnH-psbA+ITS2 was required as a complementary barcode to distinguish closely related species in complex data sets involving internationally traded timber species. Comparative analyses of family-level discrimination and species/genus ratios indicated that the inclusion of closely related species is an important factor affecting the resolution ability of barcodes for timber species verification. Our study indicates that although nuclear ITS2 is the most efficient single barcode for timber species authentication in China, complementary combinations like matK+trnH-psbA+ITS2 are required to provide broader discrimination power. These newly-generated sequences enrich the existing publicly available databases, especially for tropical and subtropical evergreen timber trees and this current timber species barcode reference library can serve as an important genetic resource for forestry monitoring, illegal logging prosecution and biodiversity projects.

Three rare spirocyclohexadienone-type neolignans, magnoflorins A-C (1-3), and three known analogs (4-6), were isolated from the leaves of Magnolia liliiflora. Magnoflorin D (4) was obtained from natural resources for the first time. The chemical structures and absolute configurations of 1-4 were elucidated through detailed analysis of HR-ESI-MS, IR

We prospectively compared clinical response and penile color duplex ultrasound results of oral tadalafil 20 mg plus low dose intracavernous injection of vasoactive agents with those of intracavernous injection and oral tadalafil 20 mg alone. We also observed the best approach to facilitate penile color duplex ultrasound and that most preferred by patients.All 56 patients with erectile dysfunction underwent penile color duplex ultrasound 3 times at an interval of at least 1 week using different pharmacological induction methods, including tadalafil mode (20 mg tadalafil), intracavernous injection mode (30 to 60 mg papaverine) and mixed mode (15 mg papaverine plus 20 mg tadalafil). Ultrasound parameters included peak systolic and end diastolic velocity, resistance index and acceleration time. Clinical response was assessed by the erection hardness score. Patient preference was determined when all tests were finished.For penile color duplex ultrasound parameters no significant difference was observed between intracavernous injection and mixed modes. However, for tadalafil mode peak systolic velocity of the 2 cavernous arteries measured 15 minutes after induction were significantly lower than for intracavernous injection and mixed modes. Also, acceleration time of the right cavernous artery measured 5 minutes after induction and left cavernous artery measured 15 minutes after induction in tadalafil mode were significantly shorter than those in intracavernous injection and mixed modes. No severe side effect occurred in tadalafil and mixed modes but 2 patients experienced priapism in intracavernous injection mode. Of the patients 55.4% preferred tadalafil mode, an incidence significantly higher than intracavernous injection (16.1%) and mixed (28.5%) modes.Oral tadalafil plus low dose vasodilator led to a significantly better clinical response than high dose vasodilator. Penile color duplex ultrasound parameters showed no difference between the 2 modes. Thus, this mixed mode emerges as a possible alternative to high dose vasodilator injection.

Accurate estimates of ammonia (NH 3 ) emissions are needed for reliable predictions of fine particulate matter (PM 2.5 ) by air quality models (AQMs), but the current estimates contain large uncertainties in the temporal and spatial distributions of NH 3 emissions. In this study, the US EPA Community Multiscale Air Quality (CMAQ) modeling system is applied to study the contributions of the agriculture–livestock NH 3 (AL-NH 3 ) emissions to the concentration of PM 2.5 and the uncertainties in the total amount and the temporal variations of NH 3 emissions and their impact on the formation of PM 2.5 for August and December 2002. The sensitivity simulation results show that AL-NH 3 emissions contribute significantly to the concentration of PM 2.5 , NH 4 + , and NO 3 − ; their contributions to the concentrations of SO 4 2− are relatively small. The impact of NH 3 emissions on PM 2.5 formation shows strong spatial and seasonal variations associated with the meteorological conditions and the ambient chemical conditions. Increases in NH 3 emissions in August 2002 resulted in >10% increases in the concentrations of NH 4 + and NO 3 − ; reductions in NH 3 emissions in December 2002 resulted in >20% decreases in their concentrations. The large changes in species concentrations occur downwind of the high NH 3 emissions where the ambient environment is NH 3 -poor or neutral. The adjustments in NH 3 emissions improve appreciably the model predictions of NH 4 + and NO 3 − both in August and December, but resulted in negligible improvements in PM 2.5 in August and a small improvement in December, indicating that other factors (e.g., inaccuracies in meteorological predictions, emissions of other primary species, aerosol treatments) might be responsible for model biases in PM 2.5 .