Search

Recently, Brushless Cascaded Doubly Fed Induction Generator (BCDFIG) has been considered as an attractive choice for grid-connected applications due to its high controllability and reliability. In this paper, a Finite Control Set Model Predictive Control (FCS-MPC) method with active and reactive power control capability in grid-connected mode is proposed for controlling the BCDFIG in a way that notable improvement of the dynamic response, ripple reduction of the active and reactive power waveforms and also better THD performance are achieved compared to the traditional approaches such as Vector Control (VC) method. For this purpose, the required mathematical equations are obtained and presented in detail. In order to validate the proposed method performance, a 1-MW grid-connected BCDFIG is simulated in MATLAB/Simulink environment. [ABSTRACT FROM AUTHOR]

In this paper, two kinds of observer-based sensorless predictive torque control methods are proposed. The predictive method is based on examining feasible voltage vectors (VVs) in a prescribed cost function. The VV that minimizes the cost function is selected. A novel robust prediction model is presented. The prediction model includes sliding mode feedbacks. The feedback gains are assigned by the H-inf method. Two kinds of observers are applied for flux and speed estimation, i.e., sliding mode full order observer and reduced order observer. In order to verify the proposed method, simulation and experimental results are presented in wide speed range. A comparison of the two methods is performed based on the results. [ABSTRACT FROM AUTHOR]

In this paper, an improved finite control set-model predictive control (FCS-MPC) with an optimized weighting factor is presented. The main goal of this paper is reducing the torque ripples when the FCS-MPC is implemented by means of the two-level inverter. For this purpose, the weighting factor is calculated via an optimization method. The optimization is based on dividing the control interval into two parts: active time for applying the active voltage vectors and zero time for applying the zero voltage. With this technique, the torque ripple is calculated as a function of weighting factor and it is optimized. The method is validated by simulations and experiments, using two-level inverter, at two speed regions (nominal speed and low speed). The results are compared with conventional FCS-MPC. [ABSTRACT FROM AUTHOR]

Reliability of real large distribution network of a city was calculated based on probabilistic method taken into account in this paper. Four different methods were used to improve reliability. Analysis of voltage sag incidence rate was done, too. In studied case it was shown that how much using improvement methods of reliability can affect voltage sag incidence rate in networks. [ABSTRACT FROM AUTHOR]