Search

Contains fulltext : 87345.pdf (Publisher’s version ) (Open Access) BACKGROUND AND PURPOSE: In the reconstruction of unicondylar femoral bone defects with morselized bone grafts in revision total knee arthroplasty, a stem extension appears to be critical to obtain adequate mechanical stability. Whether stability is still assured by this reconstruction technique in bicondylar defects has not been assessed. The disadvantage of relatively stiff stem extensions is that bone resorption is promoted due to stress shielding. We therefore designed a stem that would permit axial sliding movements of the articulating part relative to the intramedullary stem. METHODS: This stem was used in the reconstruction with impaction bone grafting (IBG) of 5 synthetic distal femora with a bicondylar defect. A cyclically axial load was applied to the prosthetic condyles to assess the stability of the reconstruction. Radiostereometry was used to determine the migrations of the femoral component with a rigidly connected stem, a sliding stem, and no stem extension. RESULTS: We found a stable reconstruction of the bicondylar femoral defects with IBG in the case of a rigidly connected stem. After disconnecting the stem, the femoral component showed substantially more migrations. With a sliding stem, rotational migrations were similar to those of a rigidly connected stem. However, the sliding stem allowed proximal migration of the condylar component, thereby compressing the IBG. INTERPRETATION: The presence of a functional stem extension is important for the stability of a bicondylar reconstruction. A sliding stem provides adequate stability, while stress shielding is reduced because compressive contact forces are still transmitted to the distal femoral bone. 01 juni 2010

Item does not contain fulltext

Item does not contain fulltext PURPOSE: This study assessed the influence of palatal cuspal coverage on the in vitro fatigue resistance and failure mode of Class II resin composite restorations including replacement of the buccal cusp in premolars. MATERIALS AND METHODS: A master model was made of a maxillary premolar with an MOD amalgam cavity and a simulated fracture of the buccal cusp from the isthmus floor to the CEJ. Using a copy-milling machine, this preparation was copied to 20 extracted human maxillary premolars (group A). Subsequently, the palatal cusp was reduced by 1.5 mm; this modified preparation was copied to 20 additional maxillary premolars (group B). Direct resin composite restorations were made in all teeth. Cyclic load (5 Hz) was applied, starting with a load of 200 N (10,000 cycles), followed by stages of 400, 600, 800, and 1,000 N at a maximum of 50,000 cycles each. Samples were loaded until fracture or to a maximum of 210,000 cycles. RESULTS: Of the restored premolars of group A, 20% withstood all 210,000 loading cycles; in group B, this figure was 55%. In group A, 19% of the fractures ended below the CEJ; in group B, 78% did. CONCLUSION: Palatal cuspal coverage increased the fatigue resistance of Class II resin composite restorations with replacement of the buccal cusp in premolars. However, fractures of restorations with cuspal coverage led to more dramatic failures that made restoration virtually impossible. This suggests caution in lowering remaining cusps for these adhesive restorations in the clinical situation.