Search

© 1965-2012 IEEE. Compared with traditional induction machine and direct current machine, permanent magnet synchronous machine (PMSM) holds many merits like higher torque ability and efficiency when high magnetic co-energy sintered NdFeB magnet is used. However, for the operation with high frequency, the resulted eddy current loss by the permanent magnet (PM) is very high and this kind of loss can bring the PM with high-temperature rise, making the PM face the risk of irreversible demagnetization. To reduce the PM eddy current loss, complete magnet segmentation is an effective method. However, taking this kind of method will increase manufacturing cost and reduce the mechanical robustness of the PMSM. Thus, a partial magnet segmentation method was proposed in the past. In this paper, a new annular partial segmentation (APS) method is proposed for the reduction of the PM eddy current loss, including single-side APS and double-side APS configurations. Considering that the additional process on the PM will reduce the mechanical robustness of the PM and the electromagnetic performance of machine, both the electromagnetic performance and the mechanical strength of the PM have been analyzed, based on 3-D finite-element method. It can be found that if the proposed new annular partial segmentation (APS) method is adopted, the eddy current loss in the PM can be reduced greatly, while the mechanical robustness of the PM can be guaranteed comparing with the traditional partial magnet segmentation method.

This paper proposes a novel permanent magnet assisted synchronous reluctance (PMAREL) machine, the main structure of this machine is quite similar to that of traditional PMAREL machine, and the main difference is that the grain-oriented silicon steel is used to replace some part of the stator teeth. The rolling direction of the grain-oriented silicon steel is along the radial direction of the machine, thus the advantage of higher permeability and higher kneel point in this material can be used to release the flux saturation problem of the traditional non-grain-oriented steel used in the PMAREL machine when the applied current density is high. Firstly, the structure of both proposed novel and traditional PMAREL machines are optimized and the design parameters are determined. Secondly the electromagnetic and mechanical performance are compared in these two machines which includes the demagnetization analysis, mechanical stress analysis when the rotor at the maximum speed, torque ability, efficiency by using the finite element method (FEM). It can be seen that the problem of stator teeth saturation in the novel PMAREL has been alleviated, and compared with the traditional PMAREL machine, the novel PMAREL has higher efficiency, wider speed range and 7% higher torque ability.