Search

In steel truss bridges, some truss members are exposed to solar radiation, while others are shaded by steel decks, which may result in large temperature gradients between truss members and ...

Taking advantage of the structural health monitoring system installed on the steel truss arch girder of the Dashengguan Yangtze Bridge, the monitoring correlation between strain and uniform...

Fatigue cracking is crucial issue for welded steel bridges that endure repeated vehicle loads. With typical fatigue-life evaluation methods, it is difficult to consider the influence of low stress amplitude. Based on existing full-range S-N curves and their formulas for base metal, a unified fatigue-life evaluation method is recommended for welded joints. The basis for construction of full-range S-N curves is to obtain the welding residual stress and stress concentration factor. In this paper, rib-to-deck welded joints are introduced as examples to demonstrate the detailed steps of a fatigue-life evaluation procedure. From the analysis of welding residual stress, it can be concluded that residual stress is influenced by the geometric dimensions of the composite members. With an increase in the geometric dimensions, the level of residual stress is increased. In addition, static-load experiments were conducted to obtain the stress concentration factor. A hot-spot full-range S-N curve was then obtain...

Using theoretical modeling combined with monitoring data, the typical dynamic and static behaviors of a continuous steel truss arch railway bridge are evaluated. The dynamic behavior involves an impact factor induced by the action of running trains, and the static behavior refers to axial bending performance and the stress distribution among different planes of the truss. The transverse position, length, and speed of running trains are introduced to conduct an analysis of their influences on the dynamic and static behaviors of the bridge superstructure. A structural safety evaluation is also conducted by comparison with the provisions recommended by design codes and by analysis of absolute stress. It is concluded that three types of members present different dynamic behaviors and that the value of the impact factor for chords B exceeds the provision recommended by the design codes. Chords C present the greatest ratio of bending stress versus axial stress. An imbalance of stress distribution exists among the three planes of the truss, and the difference is the smallest when trains run along the middle railways. Because the train-induced stress is considerably lower, the dynamic and static performances of the bridge are within the scope of safety.

The driving security of trains at high speeds is among the pivotal issues significantly affected by the smoothness of rail lines. For high-speed railway steel bridges, the fatigue cracking of typical positions under the rail lines will reduce the stiffness of the deck plate, inducing the smoothing of the rail lines. In this paper, a new theoretical approach is proposed that integrates the fatigue assessment of a typical welded joint for high-speed railway steel bridges in service. Based on the strain history data recorded by a structural health monitoring system, the theoretical approach includes various factors, including stress concentration, environmental corrosion, and train flow. Upon application in an actual high-speed railway bridge with an orthotropic steel deck, the approach was used to conduct determinative and reliable fatigue-life evaluation of the bridge. A static-load experiment was conducted to obtain the stress distribution around the weld and the difference in stress between the p...

Temperature field data from the steel truss arch girder and longitudinal displacement data from six groups of rubber bearings were collected by the structural health monitoring system for the Dashengguan Yangtze Bridge. By using long-term monitoring data, two correlations are investigated: the linear correlation between the longitudinal displacement and the temperature field (including uniform temperature and temperature gradient); and the linear correlation of the longitudinal displacements in different locations. A multivariate linear regression equation is used to model the first correlation, and a Lagrange polynomial interpolation is used to model the second correlation. The final mathematical models, representing the healthy state of the bearings, can be applied to simulate the longitudinal displacements of the main girder. Furthermore, the change regularity of longitudinal displacements for the degraded rubber bearings is revealed taking advantage of a hysteretic model and presumed envelope ...