Search

The first part of this paper presented mymargin the device-level comparison of emerging materials (In0.53Ga0.47As and 2-D materials) and device architecture (NW FETs) with s-Si FinFETs. In order to further understand the performance and energy efficiency of these device options for future technology nodes, it is required to go beyond the device-level comparison by accounting for not only intrinsic but also the extrinsic parasitic elements. In this paper, we present the comparison of s-Si, In0.53Ga0.47As, and 2-D material-based n-type MOSFETs using the circuit-level figure of merits across three successive future technology nodes. The analysis incorporates both device characteristics obtained from an advanced quantum mechanical simulation tool and circuit-level comparison, which accounts for device parasitic elements and wiring load. The results show that 2-D material DG MOSFETs present a more energy-efficient device option than s-Si and In0.53Ga0.47As FinFETs in sub-0.7-V supply voltage regime and In0.53Ga0.47As nanowire (NW) FETs can outperform s-Si multi-gate (MuG) FETs and 2-D material FETs, but when considering non-idealities, s-Si NW FETs remain both faster and more energy-efficient device option. [ABSTRACT FROM AUTHOR]

To continue with the scaling of high-performance transistors, alternate materials and device architectures are being explored as replacements for contemporary strained-silicon (s-Si) FinFETs. While III–V materials, such as In0.53Ga0.47As, offer higher electron mobilities and injection velocities than s-Si, emerging 2-D materials and nanowire (NW) device architectures promise better immunity to short-channel effects. In this paper, we present a detailed device-level performance comparison of s-Si, In0.53Ga0.47As, monolayer black phosphorus (BP), and WS2-based planar and multigate (Fin and NW) n-MOSFETs across three successive future technology nodes. The analysis incorporates both intrinsic device characteristics obtained from an advanced quantum mechanical simulation tool and the effect of nonidealities using a physics-based analytical model. The results indicate that 2-D materials, such as monolayer BP, offers higher ON currents than s-Si and In0.53Ga0.47As for planar device architectures. However, compared to modern s-Si and In0.53Ga0.47As Fin and NW FETs, monolayer BP and WS2 double-gate MOSFETs are reported to offer lower ON currents due to the smaller footprint at scaled technology nodes. [ABSTRACT FROM AUTHOR]

FETs made on 2-D semiconductors, typically without degenerate doping at the contacts, have a significant Schottky junction (SJ) resistance, which complicates transistor analysis. This paper evaluates the effect of the contact resistance on the 2-D-material FET characteristics through four-terminal (4-T) resistance measurements on WSe2 FETs, which allow studying the channel and contacts characteristics separately. Apart from showing the nonnegligibility of contact resistance, this paper enables a finer understanding of commonly observed phenomena, such as transistor performance improvement with dielectric-encapsulation is observed to have a stronger effect on the contact than the channel; the resistance of the forward-biased SJ is observed to be not negligible, but comparable to that of the reverse-biased junction; at biases commonly referred to as “low-bias,” the WSe2 FET resistance could be dominated by the contacts; and pinchoff can be observed at relatively lower current levels, being related to the channel-contact resistance ratio rather than their magnitudes. In the devices where true channel pinchoff can be verified, a correlation emerges between current saturating behavior and asymmetry in the output characteristics with respect to the drain–source bias polarity, a feature that may serve as a guide toward interpreting standard FET output characteristics in 2-D materials. [ABSTRACT FROM PUBLISHER]

In this paper, we benchmark the performance of monolayer and bilayer MoS2 FETs (MFETs) against various multigate (MuG) Si-FET options, such as FinFETs and lateral and vertical nanowire FETs, for a 5-nm node and beyond. We compare the performance metrics of all the device options at the ring-oscillator (RO) level, accounting for not only intrinsic and extrinsic parasitic elements but also interconnects. Using the atomistic two-band ballistic quantum transport simulations, we evaluate ON-current and intrinsic capacitances for MoS2-based devices. Furthermore, we calibrate two-band model currents with more sophisticated full-band diffusive simulations to obtain realistic performance metrics at the circuit level. We show that both the intrinsic and parasitic capacitances of a single-gate MFET are lesser than those of a double-gate (DG) MFET, resulting in 13% lesser energy consumption. A DG bilayer (DGBL) MFET shows the best performance among different MFETs. In comparison toMuG FETs, the DGBL MFET offers not only lower energy consumption but also 35%–45% lower speed. In the end, to meet the target performance, we evaluate the impact of the device current, contact resistance, and back-end-of-the-line load on the speed of RO with the DGBL MFET. [ABSTRACT FROM PUBLISHER]