Search

Abstract: This paper is the first of two which presents the development of a dynamic model for single-effect LiBr/water absorption chillers. The model is based on external and internal steady-state enthalpy balances for each main component. Dynamic behaviour is implemented via mass storage terms in the absorber and generator, thermal heat storage terms in all vessels and a delay time in the solution cycle. A special feature is that the thermal capacity is partly connected to external and partly to internal process temperatures. In this paper, the model is presented in detail. For verification, the model has been compared to experimental data. The dynamic agreement between experiment and simulation is very good with dynamic deviations around 10s. General functionality of the model and a more detailed comparison with experimental data are presented in Part II of this paper. [Copyright &y& Elsevier]

Abstract: This paper is the second paper out of two which present the development of a dynamic model for single-effect LiBr/water absorption chillers. The first part describes the model in detail with respect to the heat and mass balances as well as the dynamic terms. This second part presents a more detailed investigation of the model performance, including performance analysis, sensitivity checks and a comparison to experimental data. General model functionality is demonstrated. A sensitivity analysis gives results which agree very well to fundamental expectations: it shows that an increase in both external and internal thermal mass results in a slower response to the step change but also in smaller heat flow oscillations during the transient period. Also, the thermal mass has been found to influence the heat flow transients more significantly if allocated internally. The time shift in the solution cycle has been found to influence both the time to reach steady-state and the transients and oscillations of the heat flow. A smaller time shift leads to significantly faster response. A comparison with experimental data shows that the dynamic agreement between experiment and simulation is very good with dynamic temperature deviations between 10 and 25s. The total time to achieve a new steady-state in hot water temperature after a 10K input temperature step amounts to approximately 15min. Compared to this, the present dynamic deviations are in the magnitude of approximately 1–3%. [Copyright &y& Elsevier]

Abstract: A facility for experimental evaluation of innovative components forming part of a single effect LiBr–H2O adiabatic absorption chiller is described. Plate heat exchangers have been incorporated in the design. Two adiabatic absorber configurations, droplets and liquid sheets, were designed and tested and its performances parameters were experimentally determined. Evaporator limitations have been identified and included in the analysis. Liquid accumulation leads to overflow of refrigerant out of the evaporators. Some general observations, regarding particular operating conditions, are reported. The absorber performance has been characterized in terms of heat and mass transfer through the heat conductance and the effectiveness. The influence of the recirculation ratio is presented for both cases. The liquid sheet configuration has shown better evaluation parameters than droplets configuration. A significant reduction in the absorber size (up to 50%) as compared to using droplets is possible. [Copyright &y& Elsevier]